3gb05372.fm Page 2 Tuesday, June 11, 2002 12:40 PM
? This option is particularly recommended for the
CONSUMPTION DATAPROGRAMME START
programme ?Synthetics?, ?Daily? and
?Delicates?.Open the tap and press the ?Start/Pause? button.
Temperature SelectorLoadWaterEnergyApprox. Programme
? This function is particularly useful if you want The pilot lamp of the ?Start/Pause? button lights
ProgrammeDuration
to postpone spinning to a later time, or if you up.
(°C)(kg)(l)(kWh)(hours : minutes)*want to drain only.The indicator lamps show the sequence reached in
Cotton906.054**1.902:00the programme. After starting the programme, the
Note: The programme stops to ?Rinse Hold? at the
Cotton606.0491.142:20time the ?Rinse Hold? light in the programme flow sequence indication runs from left to right through
indication is on.Wash, Rinse, Spin.
Cotton405.0440.602:05
Terminate the ?Rinse Hold? option:When the sequence of the programme is finished
Synthetics602.5550.801:30the corresponding lamp goes out.
? Press the ?Rinse Hold? button again; the
Synthetics402.5550.601:20programme will terminate automatically with
DOOR LOCK
Daily403.0440.451:00the final spin cycle for the present wash
programme.The door can be opened when the ?Door Open?
Rapid Plus303.0370.400:30
? If you do not wish to spin the clothes, turn the indication is on.
Delicates401.5600.600:45programme selector knob to the ?Drain?
programme and press the ?Start/Pause? button PROGRAMME END
Wool301.0600.300:40
again when flashing.? The remaining time is on ?0:00? and all the
Handwash301.0450.300:40
?Spin Speed Reduction? buttonlights of the programme sequence indication
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized ? Every programme has an automatic predefined are off.
conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in maximum spin speed.
the table in relation to the water supply pressure and temperature, the load and the type of wash.? Press the button to set another spin speed.1. Turn the programme selector to the ??
* The remaining time indicator can similarly deviate from the values in the table, because it takes into account the position.
? If the spin speed ?0? is selected, the final
household conditions applicable at that time.2. Turn the water supply tap off.
spinning is cancelled but intermediate spin
**To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the 3. Open the door and unload the machine.
water out.peaks remain during rinse. The water is drained 4. Close the tap and leave the door ajar to allow
out only.
?Easy Ironing? buttonthe drum to dry out.
ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE ? Can be used together with Cotton, Synthetics and
PROGRAMMEDaily programmes to make ironing easier.START DELAYCHANGE THE PROGRAMME, TEMPERATURE,
? Increases the water quantity and the clothes are OPTIONS AFTER PROGRAMME START
Add the detergents as described in the programme The ?Start Delay? allows to run the machine at the
table or in the chapter ?Detergents and Additives? in spun very soft.consumer?s convenience, for example at night 1. Press the ?Start/Pause? button to pause the
the booklet.?Eco Wash? buttonwhen electricity is cheaper.programme. The light flashes.
1. Turn the programme selector knob to the ? The duration of the wash is extended and the ? Select programme, temperature and options.2. Select the new programme (with temperature),
desired programme.temperature reduced to save up to 40% of energy ? Press the ?Start Delay? button to select the any options and another spin speed if you
2. The remaining time display shows the duration of but maintaining good washing results.delay time by 1 to 23 hours;want.
the chosen programme (in hours and minutes) ?Prewash? button?Press the ?Start/Pause? button. 3. Press the ?Start/Pause? button again. The
and the pilot lamp of the ?Start/Pause? button ? Only for heavily soiled loads (for example sand, ? The time delay indication disappears when the new programme continues at the same position
is flashing.granular dirt) sensible. The cycle time increases programme starts and it is replaced by the
where the previous programme was
3. The programme sequence and the predefined remaining time.
approximately 15 min.interrupted. Do not add detergent for this
spin speed indication corresponding to the ? The number of hours preselected can later be
selected programme lights up.?Intensive Rinse? buttonprogramme.
? More water and a longer time in rinse cycle is reduced pressing again the ?Start Delay?
The recommended temperature (see the indicator) CANCEL A PROGRAMME BEFORE THE END
added.button.
can be altered by pressing ?+? or ?-? button.
? This option is particularly suitable for areas with To cancel the ?Start Delay?.1. Press the ?Start/Pause? button to pause the
SELECT ANY DESIRED OPTIONvery soft water, washing baby linen and helps ? Turn the programme selector to the ? ? programme. The light flashes.
people with allergies.position.2. Set the programme selector to ?Drain?. The
Selecting any option the indication lights up.?Rinse Hold? button? Reselect the desired programme and options spin indicators show ?0? and the remaining
When the combination of programme, additional
? The laundry remains in the last rinse water and press the ?Start/Pause? button.time shows ?0:02?.
options and temperature is not possible, the
without progressing to the final spin cycle to 3. Press the ?Start/Pause? button to start the
indication lights switch off automatically.
Unsuitable combinations of options are avoid creasing and prevent colours from drain programme.
changing.
deselected automatically.
Whirlpool is a registered trademark of Whirlpool USA
5019 301 05372
Black process 45.0° 100.0 LPI |
ACEC
