1/8"
5/16" screws(3 mm)
Top hinge
Door closure3/4"
(some models)(18 mm)
Center hinge
5/16" pin
hex nut
Center hinge
bracket
Center hinge
Phillips screws
Door closure
Plug
(some models)
(some models)
11. Replace freezer door handles.
Models with freezer handle cap.
Bottom hinge? Mount handle to opposite side of door using
mounting screws removed in previous step.
3/8" ? Angle front edge of handle cap downward toward
screwsback lip of freezer handle. Verify bottom tab on
freezer cap slides under rear lip of freezer handle.
Snap rear edge of handle cap in place. Place 2
button plugs in empty mounting holes.
! CAUTION
Protect soft vinyl or other flooring with cardboard, rugs
or other protective material to avoid property damage.
Handle
9. Reverse doors as necessary by performing thecap
following steps:
? Remove button plugs from opposite side ofScrews
refrigerator cabinet using putty knife covered with
masking tape. Insert button plugs in holes left from
hinge removal.
Freezer
? Remove freezer door internal support rod locatedhandle
underneath freezer handle. Reinstall internal
support rod in hinge hole on opposite side of door.
Models without freezer handle cap.
10. Rehang doors by replacing bottom, center, and top? Place hinge shim on non-hinge side of door. Large
hinges, along with freezer and refrigerator doors on
hole in hinge shim must line up with hole created
opposite side of refrigerator performing steps 2-8 in
from hinge reversal.
reverse order.
3
?Use a penny at top to space door /4" (18 mm)
from cabinet.
?Handle side of door should be approximatelyFreezer handle
1shim
/8" (3 mm) higher than hinge side.
Hinge hole
? Replace freezer handle on non-hinge side of door
with screws previously removed.
6 |
ACEC
