InstallationGrounding Instructions
Unpacking Equipment
? Inspect equipment for damage such as dents in door or!WARNING
dents inside oven cavity.
? Report any dents or breakage to source of purchaseTo avoid risk of electrical shock or death, this
immediately. Do not attempt to use oven if damaged.equipment must be grounded.
? Remove all materials from oven interior.
? If oven has been stored in extremely cold area, wait a
few hours before connecting power.
!WARNING
To avoid risk of electrical shock or death, do not alter
Radio Interference
Microwave operation may cause interference to radio,the plug.
television, or similar equipment. Reduce or eliminate
interference by doing the following:This equipment MUST be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
? Clean door and sealing surfaces of oven according toelectric shock by providing an escape wire for the
instructions in ?Care and Cleaning? section.
? Place radio, television, etc. as far as possibleelectric current. This oven is equipped with a cord having
from oven.a grounding wire with a grounding plug. The plug must
? Use a properly installed antenna on radio, television,be plugged into an outlet that is properly installed and
grounded.
etc. to obtain stronger signal reception.
Equipment PlacementConsult a qualified electrician or servicer if grounding
? Do not install equipment next to or above source ofinstructions are not completely understood, or if doubt
exists as to whether the equipment is properly
heat, such as pizza oven or deep fat fryer. This couldgrounded.
cause microwave oven to operate improperly and could
shorten life of electrical parts.
? Do not block or obstruct oven filter. Allow access forDo not use an extension cord. If the product power cord
cleaning.is too short, have a qualified electrician install a three-
slot receptacle. This oven should be plugged into a
? Install oven on level countertop surface.separate 60 hertz circuit with the electrical rating as
shown in the appropriate drawing. This model requires a
208-230 supply voltage. When a microwave oven is on a
circuit with other equipment, an increase in cooking
times may be required and fuses can be blown.
A
B
A
NEMA 6-20R/6-20P
230V/208V-20AMP
DQ22HS
A?Allow at least 11 inches/3.81 centimeters of clearanceGrounded Receptacle and Plug
around top and sides of equipment. Proper air flow around
equipment cools electrical components. With restricted air flow,
oven may not operate properly and life of electrical parts is
reduced.
B?Allow at least 5/8 inche/1.58 centimeters between air
discharge on back of equipment and back wall. Cord wrap
provides proper spacing.
Oven Clearances
5 |
ACEC
