Using CANCEL DRAIN
CANCEL Push the CANCEL l When the dishwasher is drained, all signal
DRAIN DRAIN Button to stop lights will go off.
any cycle at any time l Select a new cycle, if desired.
for any reason. NOTE: When CANCEL DRAIN is pushed, the timer
l All dishwasher ac- automatically moves to a drain position. You
tion will stop and may hear the timer ticking or clicking as it
water will drain from advances. This is a normal sound.
F the dishwasher. If CANCEL DRAIN is pushed near the end of a
l The draining will take about 2 minutes. The cycle, the CLEAN Signal Light may come on. To
RINSE/DRY Signal Light will be on during this turn it off. Push CANCEL DRAIN again.
time.
The signal lights
WATER HEATING HOLD Light - Comes on when
the dishwasher is heating water (to 145?F/63?C)
WATER during the wash or rinse portion of the cycle.
HEATING RINSE/ WASH Light-Comes on when washing action
DELAY HOLD WASH DRY CLEAN starts. Stays on until water from the last wash
is drained away.
m m m m m RINSE/DRY Light-Comes on during final rin-
ses. Stays on during the ?dry? part of the
Signal lights go on and off during a cycle to cycle. It goes off after the last rinse if the AIR
let you know what your dishwasher is doing. DRY Option is used.
DELAY Light-Comes on when DELAY WASH CLEAN Light - Comes on when a cycle is over.
Control-is used. Stays on until selected cycle It will siay on until CANCEL DRAtN Button is
starts. pushed.
To add a dish after starting
1. To be sure the added item is washed, 3. Open the door and add the dish
make sure the WASH Signal Light is still
on and that the covered section of the
detergent dispenser has not opened.
2. Unlatch the door to stop the cycle, but 4. Close the door. Do not latch It. Wait 30
don?t open it until the spray arms stop seconds for air in the dishwasher to warm
spinning. up. This helps reduce the amount of
moisture that can come from the vent
when restarting the cycle.
5. Latch the door. The dishwasher will restart
and continue the cycle. |
ACEC
