To add a dish after starting
4. Close the door, Do not latch it. Wait 30 sec-
1. To be sure the added item is washed and
onds for air in the dishwasher to warm up.
rinsed, make sure the Cycle Control Knob This helps reduce the amount of moisture
has not passed LOW ENERGY WASH.
that can come from the vent when restart-
2. Lift up on the door latch to unlatch the door ing the cycle.
and to stop the cycle. Don?t open the door 5. Latch the door. The dishwasher will Start
until the spray arms stop spinning. from where it stopped.
3. Open the door and add the dish.
The CLEAN Signal Light
The CLEAN Signal Light will come on when a To turn light off, turn the Control Knob clock-
washing cycle is complete. wise slightly until the light goes off.
Energy saving tips
You can help save energy if you:
1. Wash full loads. Running a half-filled dish- 2 Use the LOW ENERGY WASH Cycle whenever
washer uses the same amount of electricity possible. It uses less hot water and energy
and hot water as a fully loaded machine. than otherwash cycles.
3. Air dry dishes when You don?t need a rapid 4. load correctly for best washing results. In-
drying cycle. Allow longer drying times correct loading may cause poor washing
[overnight). and the need to rewash all or part of the
load.
5. Don?t pre-rinse normally soiled dishes. Se-
lect the correct cycle for the load and use
the recommended amount of detergent for
good washing results without hand rinsing.
6. Use your dlshwasher dunng off-peak hours
Local utilities recommend this to avoid
heavy usage of energy at certain times of
dav
7. Kitchen cleanup can be done quickly and
efficiently through the use of Your dishwasher.
Most appliance parts that can fit in the dish-
washer can be cleaned by it. Burned-on soil,
however, should be cleaned by hand. |