WHIRLPOOL DU8950XB0 Instruction Manual

3. Turn the Cycle Control knob clockwise to
point to the desired cycle. Heavy Wash
and Pots 8 Pans cycles share the same
spot on the dial. China Crystal and Light
Wash cycles also share a spot on the
dial. The Cycle Selector buttons deter-
mine which cycle operates. You will feel a
definite stop at each cycle mark. The
dishwasher will automatically start the
cycle you selected.
NOTE: If the door is latched, you will hear
cycles start and stop as the knob passes
each cycle mark. This is normal and will
not hurt the dishwasher. If you prefer, you
can set cycles with the door unlatched.
Starting your dishwasher using delay wash
You can set the dishwasher to start a cycle from 1 to 6 hours later.
1. Push desired Cycle Selector button.
2. Push desired Option Selector button(s).
3. Turn Cycle Control knob clockwise to the
number of hours (from 1 to 6 hours) you
want the dishwasher to delay before the
selected cycle starts.
4. Close and latch the door. The DELAY
signal light will come on until the selected
cycle starts.
NOTE:
l You can add items while time is counting
down. Close and latch the door. The Cycle
Control knob will not advance if the door is
unlatched.
l Rinse & Hold, Light Wash and China
Crystal cycles cannot be delayed.
Adding a dish during a cycle
You can add a forgotten item to the dishwasher anytime before the Cycle Control knob
reaches LIGHT WASH. See page 9.
1. Lift up on the door latch to unlatch the seconds for air in the dishwasher to warm
door and stop the cycle. Wait a moment up. This helps reduce the amount of
for the spray action to stop before open- moisture that can come from the vent
ing the door. when restarting the cycle.
2. Open the door and add the dish. 4. Press door in to latch ft. The dishwasher
3. Close the door. Do not latch it. Wait 30 will start where it stopped.
7