8051220 v15 (c41) 7/1/98 9:08 AM Page 6
STARTING YOUR DISHWASHER
Starting a wash cycle
1.Load the dishwasher. See the OLoading6.Run hot water at the sink nearest the
Your Dishwasher� section.dishwasher until water is hot.
Turn off water.
2.Spin the spray arms. They should turn7.Press a Cycle pad. If desired, press one
freely.or more Options pads. See
the �Setting the Controls�
section.
NOTE: Normal Wash, Light
Wash and Rinse Only share
the same pad. The Cycle Control knob
3.Add detergent. See the OUsing the determines which cycle operates.
Dispensers� section.
8.Turn the Cycle Control knob clockwise to
the desired cycle. You will
feel a definite Ostop� at each
cycle mark. The dishwasher
automatically starts the cycle
4.Add rinse agent, if needed.
you select.
NOTE: If the door is latched, you will
hear the cycles start and stop as the
control knob passes each cycle mark.
This is normal and does not hurt the
dishwasher. If you prefer, you can set
5.Close door firmly until it latches.the Cycle Control knob with the door
unlatched.
Stopping the dishwasher
You can stop your dishwasher anytimeOR
during a cycle. All you have to do is:
Y Turn the Cycle Control knob slowly
Y Open the door slightly. Wait for any fillingclockwise until you hear water draining.
or spraying action to stop before openingLet the dishwasher drain completely. Then
the door all the way. Close the door toopen the door and turn the Cycle Control
continue the cycle.knob to Off.
6 |
ACEC
