5. Remove the spring clamp from the water outlet and
separate from the water supply valve; drain water into
Storing Your Dishwasherpan.
Storing for the summer6. Reconnect both water inlet and water outlet to the
water supply valve.
Protect your dishwasher during the summer months by
turning off the water supply and power supply to the 7. Empty the pan and reposition it under the water pump.
dishwasher.
8. Remove the clamp and disconnect the drain hose from
Moving or winterizing your dishwasherthe water pump; drain water into pan.
Protect your dishwasher and home against water damage 9. Reconnect drain hose to the water pump, being sure
due to freezing water lines. If your dishwasher is left in a to position the clamp over the connection.
seasonal dwelling or could be exposed to near freezing
temperatures, have a qualified person do the following:10.Replace the lower access panel.
1. Disconnect power supply to the dishwasher.NOTE: If your dishwasher is connected to a garbage
disposal, do not run water into the sink after winterizing.
2. Turn off water supply to the dishwasher.This could cause water to refill the drain hose on your
dishwasher.
3. Remove the 4 screws on the lower access panel.
Remove the lower access panel.Reconnecting your dishwasher
1. Remove the 4 screws on the lower access panel and
remove lower access panel.
2. Turn on the water supply to dishwasher.
3. Turn on power supply to dishwasher.
4. Run dishwasher through a complete cycle and check
for leaks.
5. Replace lower access panel.
4. Place a shallow pan under the water supply valve.
Then, use a wrench to disconnect the water inlet from
the water supply valve. Separate the water inlet from
the water supply valve and drain water into the pan.
12
3456
1. Water outlet
2. Spring clamps
3. Water supply valve
4. Water inlet
5. Water pump and motor
6. Drain hose
16 |
ACEC
