4. Remove dirt and lint from the condenser fins and the 7. Remove the right-hand screw and loosen the left-hand
unit compartment with a brush attachment on a screw. Lift the cutter grid up and out and over the left-
vacuum cleaner.hand screw.
NOTE: Make sure the plastic spacer from the right-
hand side of the cutter grid bracket stays with the
cutter grid.
5. Replace the lower access panel using the four screws.
6. Plug in ice maker or reconnect power.
1. Cutter Grid Harness
Cleaning the Interior 2. Screw
3. Cutter Grid
Components4. Ice Level Sensor Harness
5. Plastic Spacer
1. Unplug ice maker or disconnect power.6. Screw
2. Open the storage bin door and remove any ice that is in
the bin.
8. Remove the two screws that hold the water pan in
3. Remove the drain cap from the water pan and drain place. Push down with one hand on the front of the pan
thoroughly. Replace the drain cap.while pulling forward on the bottom back side.
4. Remove the three screws that hold the cutter grid
cover in place.
5. Unplug the wiring harness from the left side of the
cutter grid.
9. Wash the interior components (cutter grid, exterior of
hoses, and water pan) and the storage bin, door
gasket, and ice scoop with mild soap or detergent and
warm water. Rinse in clean water. Then clean the same
parts with a solution of 1 tablespoon (15 mL) of
household bleach in 1 gallon (3.8 L) warm water. Rinse
again thoroughly in clean water.
NOTE: Do not remove hoses. Do not wash plastic parts
1. Cutter Grid Coverin dishwasher. They cannot withstand temperatures
2. Screwsabove 145°F (63°C).
10.Replace water pan by pushing back on the bottom with
6. Unplug the ice level sensor from the right side of the one hand while pushing up and back on the top.
cutter grid. Pull the ice level sensor down and forward Secure the water pan by replacing both screws.
away from the cutter grid.
11.Check the following:
nDrain cap from the water pan is in place.
nHose from water pan is inserted into storage bin
drain opening.
12.Slide the cutter grid back into place and secure it by
replacing the right-hand screw and plastic spacer. Then
tighten the left-hand screw. Reconnect the cutter grid
and ice level sensor harnesses.
13.Plug in ice maker or reconnect power.
14 |
ACEC
