Water Filtration System
Non-indicator Water Filter (on some models)
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
If your refrigerator does not have the water filter status light, you after the system.
should change the water filter cartridge at least every 6 months
depending on your water quality and usage. If the water flow to
the water dispenser or ice maker decreases noticeably before
Water Filter Status Light (on some models)6 months have passed, replace the water filter more often.
The water filter status light will help you know when to change Using the Dispenser Without the Water Filter
your water filter. The light will change from green to yellow. This
tells you that it is almost time to change the filter. It is
recommended that you replace the water filter when the status You can run the dispenser without a water filter. Your water will not
light changes to red OR water flow to your water dispenser or ice be filtered.
maker decreases noticeably. The filter should be replaced at least 1. Remove the water filter.
every 6 months depending on your water quality and usage.2. Slide the cap off the end of the filter and replace the cap in the
After changing the water filter, reset the water filter status light. base grille.
The status light will change from red to green when the system is IMPORTANT: Do not discard the cap. It is part of your
reset. refrigerator. Keep the cap to use with the replacement filter.
REFRIGERATOR CARE
3. Wash stainless steel and painted metal exteriors with a clean
sponge or soft cloth and a mild detergent in warm water.
Cleaning
4. There is no need for routine condenser cleaning in normal
home operating environments. If the environment is
WARNINGparticularly greasy or dusty, or there is significant pet traffic in
the home, the condenser should be cleaned every 2 to
3 months to ensure maximum efficiency.
If you need to clean the condenser:
 Remove the base grille.
 Use a vacuum cleaner with a soft brush to clean the grille,
the open areas behind the grille and the front surface area
Explosion Hazardof the condenser.
Use nonflammable cleaner. Replace the base grille when finished.
5. Plug in refrigerator or reconnect power.
Failure to do so can result in death, explosion, or fire.
Both the refrigerator and freezer sections defrost automatically. Changing the Light Bulbs
However, clean both sections about once a month to avoid NOTE: Not all bulbs will fit your refrigerator. Be sure to replace the
buildup of odors. Wipe up spills immediately.bulb with one of the same size, shape and wattage. On some
IMPORTANT: Because air circulates between both sections, any models, the dispenser light requires a heavy duty 10-watt bulb. All
odors formed in one section will transfer to the other. You must other lights require a 40-watt bulb. Replacement bulbs are
thoroughly clean both sections to eliminate odors. To avoid odor available from your dealer.
transfer and drying out of food, wrap or cover foods tightly.1. Unplug refrigerator or disconnect power.
To Clean Your Refrigerator:2. Remove light shield when applicable.
NOTE: Do not use abrasive or harsh cleaners such as window
sprays, scouring cleansers, flammable fluids, cleaning waxes, NOTE: To clean the light shield, wash it with warm water and
concentrated detergents, bleaches or cleansers containing liquid detergent. Rinse and dry the shield well.
petroleum products on plastic parts, interior and door liners or 3. Remove light bulb and replace with one of the same size,
gaskets. Do not use paper towels, scouring pads, or other harsh shape and wattage.
cleaning tools.4. Replace light shield when applicable.
1. Unplug refrigerator or disconnect power.
5. Plug in refrigerator or reconnect power.
2. Hand wash, rinse, and dry removable parts and interior
surfaces thoroughly. Use a clean sponge or soft cloth and a
mild detergent in warm water.
8 |
ACEC
