humidity in room is high, push
switch toward HI to prevent
condensation. When humidity is
low, push switch toward LO to
conserve electricity.
l&Y%&
Taking care of
2. Turn cold control to OFF, and
your freezer disconnect service cord
Defrosting and cleaning from wall outlet.
Complete defrosting should be
done a bout once a year. For in-
between defrosting, remove
Exterior signal light - Located on frost by scraping with CI plastic
the right side of the base grille, scraper. Do not use an ice pick,
automatically indicates any knife or other sharp-pointed
power interruption to the freezer. tool. You could damage the
When power is being supplied. refrigerant coils.
the light will glow If light does
not glow, check immediately.
The electrrc current may be off;
the freezer may be discon-
nected from the outlet; or the
warning light may be burned
out.
FOLLOW THESE
3. Take out glide-out basket.
STEPS WHEN
Wash in warm, soapy water;
DEFROSTING AND rrnse and dry
To remove glide-out basket at
CLEANING: bottom, pull it out until it stops.
Lift basket up and out. To
replace, insert basket into
rear slides and lower into
position. Push basket into
freezer.
Key eject lock
Your freezer is equipped with CI
key eject lock which can help
reduce the hazard of child en-
trapment. To lock or unlock the
freezer it IS necessary to man-
ually hold the key tn the lock
whrle turning. The lock IS
spring loaded so tne key can
not be left In the lock
If key is lost, a replacement can 1 Remove frozen foods and
be obtained from {our dealer or wrap packages individually
a Whirlpool TECH-CARE service In several thicknesses of
agent Always give complete newspaper and cover with a
model and serial numbers of blanket. Food handled this
your freezer when requesting a way will stay frozen several
replacement key hours
3. |
ACEC
