Install properly.. Remove sales labels...
Remove the Consumer Buy Guide label and any
inside labels before using the freezer
-l~,l-A~L To remove any remaining glue:
! 1 I I 1 1 1. Rub briskly with thumb to make a ball, then
remove.
Allow room to open Ild 1 I
OR
w 2 Inches at back 2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] be-
fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
3 inches 3 inches
4lr bon tetrachioride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Care 81 Service label
on inside lid or Tech Sheet on back of cabinet.
I, Check the strength of the floor. It should hold the
weight of a fully loaded freezer.
Clean it...
2. Pick a safe place, indoors, away from in-
flammables such as gasoline. Clean your freezer before
using it. See cleaning
3. Allow at least 3 inches (7.5 cm] air space on all instructions on page 6.
sides of freezer and 2 inches (5 cm] at back. Leave
room at top for lid to open all the way.
4. It should not be necessary to remove the lid during
installation. If, for any reason, the hinges need ad-
justment, see your authorized WHIRLPOOL dealer.
5. Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc.
Level chest freezet..
from end to end and front to back so that the lid will Plug it in...
seal properly
type wall receptacle
Refainin\g Clip
Freezer /
Power Plug
grounding -plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided. Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord.
Attach retaining clip over power cord plug
from literature package inside the freezer.
4 |
ACEC
