A 120 Volt, 60 Hz., AC only, 15 ampere fused
Plug It In... electrical supply is required. It is recommended
3-prong grounding
that a separate circuit serving only this appli-
type wall receptacl ance be provided. The receptacle should not
be controlled by a wall switch or pull chain.
Attach retaining clip over power cord plug
from the literature package inside your freezer.
Do not use an extension cord.
Freezer
power cord
Recommended Grounding Method
Using your freezer Adjusting Cold Control...
l Turn control to higher number for colder
temperatures.
l Turn to lower number for less cold temperatures.
Cooling Freezer First...
l Allow freezer to cool 6 to B hours before filling
with frozen food.
l Let it cool overnight before adding large
amount of unfrozen food.
Note: When freezer is first started the compressor
will run constantly until the cabinet is cooled. It
may take up to 6 to B hours or longer, depending
on room temperature and the number of times
the freezer lid is opened.
After the cabinet is cooled the compressor will
turn on and off as needed to keep freezer at
Setting the Cold Control... proper temperature.
1. Insert a coin in the slot of the Cold Control to
The outside of your freezer may feel warm. This
turn it.
is normal. The freezer?s design and main function
2. Turn control to Number 3. This setting will main- is to remove heat from packages and air space
tain zero zone temperatures under normal op- inside the freezer. This heat is transferred to the
erating conditions.
room air so the walls of the freezer may be warm.
Exterior Signal light...
automatically warns of any unexpected power If the signal light is not glowing, immediately
failure. check:
0 for power interruption,
l the power plug; it may be disconnected from
the outlet,
l the warning light; it may be burned out.
To replace burned out signal light:
1. Unplug power cord from outlet.
2. Carefully snap out light cover and assembly
with a screwdriver by inserting it under the
end of metal edge of the light. Be careful not
Signal light cover to chip finish on freezer.
3. Unplug burned out signal light and replace
with a new one. Signal light can be ordered
from your Whirlpool dealer.
4. Then, snap light assembly into place.
5. Plug cord into outlet.
3 |
ACEC
