Before you pluc1 it in
Before using your freezer, you are personally . is properly maintained.
responsible for making sure that it...
. is in a dry sheltered area.
l is installed and leveled on a floor that will
. is used in an area where the room tempera-
hold the weight, and in an area suitable for
ture will not exceed 110 F, (43 3 C).
its size and use.
. is not run where there are explosive fumes.
l is connected only to the right kind of outlet,
. is not used by children or others who may not
with the right electric supply and grounding
understand how it should be used.
(see page 3).
. is not loaded with food before it has time to
l is used only for jobs expected of home
freezers. get properly cold.
l is not near an oven, radiator or other heat
source.
Install Properly.. . level Chest Freezer.. .
from end to end and front to back so that the Ird
will seal properly.
Check with level
Allow room to open lid
l-1 I 2 inches at back 1
I II
IW I
r--l,
1
Remove Sales label...
I 1111
Remove the Consumer Buy Guide label before
riinches Jinches1li, using the freezer. Remove any left over glue with
rubbing alcohol.
f
Note: DO NOT REMOVE the Care and Ser-
vice label on the inside lid. This permanent
label provides immediate information
1. Check the strength of the floor. It should hold should it be needed. Do not remove Tech
weight of fully loaded freezer. Sheet permanently attached to inside of
service panel.
2. Allow at least 3 inches (7.5 cm) air space on
all sides of freezer and 2 inches (5 cm) at
Clean It...
back. Leave room at top for lid to open all the
way. Clean your freezer before using it See clean-
ing instructions on page 4.
3. It should not be necessary to remove the lid
during installation. If, for any reason, the hinges Defrost Drain Cover.. .
need adjustment, see your authorized Installing Defrost Drain Cover:
WHIRLPOOL dealer.
1. Remove cover from literature package.
2. Check drawing on page one for placement
4. Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc. 3. Install cover.
2 |
ACEC
