Install properly.. . Remove sales labels.. .
r
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator
To remove any remaining glue:
1 Rub briskly with thumb to make a ball then remove
OR
2 Soak area with dishwashing detergent solution [I
teaspoon detergent tn 1 quart warm water] before
removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
11
Do not remove the Tech Sheet fastened under
I I
the refrigerator at the front.
I---
I
Clean it.. .
ggg$
L-J -\ ,I
,L Clean your refrigerator ,,
/n
before using It
See cleaning InstructIons L
on pages 7 and ,8
1 Allow 3 inches (7 5 cm] between overhead cable
nets and refrigerator top
2 Allow at least an Inch (2 5 cm) between the
refrigerator condenser on the back and the wall
3 Allow ?,!. Inch (1 25 cm) on each side of the
refrtgerator for ease of lnstallatlon Plug it in...
4 If the refrigerator IS to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider 3-prong
grounding type
wall receptacle
Level refrigerator-freezer...
3-drong
11111 grounding plug
1)
Refrigerator
Power Cord
Raise tower RECOMMENDED GROUNDING METHOD
This refrigerator has 2 threaded levelllng legs that A 115 Volt, 60 Hz, AC only 15 or 20 ampere fuseu
are shipped in a separate package and properly grounded electrlcal supply IS re-
1. Screw these legs all the way Into bolt holes in the quired It IS recommended that a separate circuit
bottom front corners of the refrigerator serving only this appliance be provided
2 Slide the refrigerator Into place Do not use an extension cord. Use a recep-
3 Adjust front legs to level the refrigerator tacle which cannot be turned off with a switch
- To raise corners, turn legs In direction shown or pull chain. See lndlvidual electrical require-
- To lower corners, turn legs in direction shown ments and grounding InstructIon sheet In your liter-
4 Check with level ature package
A |