Install properly.. . Remove sales labels.. .
Remove the Consumer Buy Gurde label, tape and
. any inslde labels before using the refrigerator.
To remove any remaining glue:
I, Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetmchloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator
before using it.
See cleaning instructions
on page 8
.I?-- I .I_.,--L.x~I .s--7w-.
1. Allow 3 inches (7 5 cm) between overhead cabr- Plug it in...
nets and refrrgerator top.
2 Allow at least an inch (2 5 cm) between the
refrigerator condenser on the back and the wall J-prong grounding
3 Allow ?/2 Inch (1.25 cm) on each side of the
refrigerator for ease of Installation. type wall receptacle,
4 If the refrigerator IS to be agarnst a wall, you might
want to leave extra space on the hrnge side so the
door can be opened wider.
Level refrigerator-freezer.. .
Leveling screw Rdlse 1
Rsfrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply IS re-
Right to Raise; quired It is recommended that a separate circuit
Use Screwdriver Left to Lower serving only this appliance be provided
to Adjust
Do not use an extension cord. Use a recep-
1 To raise front, turn each screw to the right tacle which cannot be turned off with a switch
2 To lower front, turn each screw to the left or pull chain. See individual electrical require-
ments and grounding instruction sheet in your liter-
3 Check with level ature package.
4 |
ACEC
