Install properly.. . Level refrigerator-freezer.. .
Use Screwdriver Leveling screw
to Adjust
Right to Raise;
Left to Lower
1 To raise front, turn each screw to the right
2 To lower front, turn each screw to the left
3 Check with level
Clean it.. .
Clean your refrigerator
before using it
See cleaning instructions
on page 8,
i A
1 Allow 3 Inches (7.5 cm] between overhead cabi-
nets and refrigerator top
2 Allow at least an inch (2.5 cm] between the
refrigerator condenser on the back and the wall.
3. Allow K inch (1.25 cm] on each side of the Plug it in...
refrigerator for ease of Installation.
4 If the refrigerator IS to be against a wall, you might
3-prong grounding
want to leave extra space on the hinge side so the
type wall receptacle
door can be oDened wider.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator.
To remove any remaining glue:
1 Rub briskly with thumb to make a ball then remove
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1 Refrigerator
Power Cord
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the RECOMMENDEDGROUNDING METHOD
material.
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
NOTE: DO NOT REMOVE ANY PERMANENT IN-
and properly grounded electrical supply IS re-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
quired. It IS recommended that a separate circuit
Do not remove the Tech Sheet fastened under
serving only this appliance be provided.
the refrigerator at the front.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See individual electrical require-
ments and grounding instructlon sheet in your liter-
ature package |
ACEC
