If you need to adjust temperatures, use the settings listed in the
chart below as a guide. On models with two controls, adjust the Remember
refrigerator temperature first. Wait at least 24 hours between
adjustments and then recheck the temperatures. The quality of your ice will be only as good as the quality of the
water supplied to your ice maker. Avoid connecting the ice
CONDITION/REASON:ADJUSTMENT:
maker to a softened water supply. Water softener chemicals
(such as salt) can damage parts of the ice maker and lead to
REFRIGERATOR too warmREFRIGERATOR or
poor quality ice. If a softened water supply cannot be avoided,
TEMPERATURE Control one
make sure the water softener is operating properly and is well
setting higher
maintained.
FREEZER too warm/too FREEZER or TEMPERATURE Never use anything sharp to break up the ice in the bin or
little ice Control one setting higherbucket. This can cause damage to the ice container and the
MAX ice production switchdispenser mechanism.
Do not store anything on top of or in the ice maker or ice bin.
REFRIGERATOR too coldREFRIGERATOR or
TEMPERATURE Control one
setting lower
Water Dispenser
FREEZER too coldFREEZER or TEMPERATURE
Control one setting lower
WARNING
Crisper Humidity Control
(on some models)
You can control the amount of humidity in the moisture-sealed
crisper. Adjust the control to any setting between LOW and HIGH.
LOW (open) for best storage of fruits and vegetables with skins. Cut Hazard
HIGH (closed) for best storage of fresh, leafy vegetables. Use a sturdy glass when dispensing ice or water.
Failure to do so can result in cuts.
Ice Maker
IMPORTANT:
Turning the Ice Maker On/OffAfter connecting the refrigerator to a water source, flush the
water system by dispensing water into a sturdy container until
To turn the ice maker ON, simply lower the wire shutoff arm.
you draw and discard 2 to 3 gal. (8 to 12 L) of water, or for
To manually turn the ice maker OFF, lift the wire shutoff arm to the approximately 5 minutes after the water begins dispensing.
OFF (arm up) position and listen for the click.The flushing process cleans the water system and clears the
air from the lines. As the air is cleared from the lines, water
NOTE: Your ice maker has an automatic shutoff. As ice is made,
may spurt out of the dispenser.
the ice cubes will fill the ice storage bin and the ice cubes will
raise the wire shutoff arm to the OFF (arm up) position. Do not Allow several hours for the refrigerator to cool down and chill
force the wire shutoff arm up or down.water.
Dispense enough water every week to maintain a fresh supply.
To Dispense Water:
There are two water dispenser buttons for use with different sizes
of containers.
1. Press a sturdy glass against the back button or hold a
container under the dispenser while pressing the front button.
2. Remove the glass or release the front button to stop
dispensing.
Ice Production Rate
Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced.
The ice maker should produce approximately 8 to 12 batches
of ice in a 24-hour period.
To increase ice production, lower the freezer and refrigerator
temperature. See ?Using the Controls.? Wait 24 hours
between adjustments.
For maximum ice production (on some models), push the
switch to ICE PLUS. The ice maker should produce 16 to
20 batches of ice in a 24-hour period in the Ice Plus mode.
9 |
ACEC
