To Clean Your Refrigerator:
Water Filtration SystemNOTE: Do not use abrasive or harsh cleaners such as window
sprays, scouring cleansers, flammable fluids, cleaning waxes,
NOTE: Do not use with water that is microbiologically unsafe
concentrated detergents, bleaches or cleansers containing
or of unknown quality without adequate disinfection before or
petroleum products on plastic parts, interior and door liners or
after the system.
gaskets. Do not use paper towels, scouring pads, or other harsh
cleaning tools.
Water Filter Status Light (on some models)
1. Unplug refrigerator or disconnect power.
2. Hand wash, rinse, and dry removable parts and interior
The water filter status light, located at the top of the refrigerator
compartment, will help you know when to change your water filter. surfaces thoroughly. Use a clean sponge or soft cloth and a
When the water filter status light changes from green to yellow, mild detergent in warm water.
this tells you that it is almost time to change the water filter. It is 3. Wash stainless steel and painted metal exteriors with a clean
recommended that you replace the water filter when the water sponge or soft cloth and a mild detergent in warm water.
filter status light changes to red OR water flow to your water
4. There is no need for routine condenser cleaning in normal
dispenser or ice maker decreases noticeably.
home operating environments. If the environment is
After changing the water filter, reset the filter status light by particularly greasy or dusty, or there is significant pet traffic in
pressing the button. The status light will change from red to green the home, the condenser should be cleaned every 2 to
when the system is reset. 3 months to ensure maximum efficiency.
If you need to clean the condenser:
Non-indicator Water Filter (on some models)
Remove the base grille.
If your refrigerator does not have the water filter status light, you Use a vacuum cleaner with a soft brush to clean the grille,
should change the water filter every 6 to 9 months depending the open areas behind the grille and the front surface area
upon your usage. If the water flow to the water dispenser or ice of the condenser.
maker decreases noticeably before 6 months have passed,
Replace the base grille when finished.
replace the water filter more often.
5. Plug in refrigerator or reconnect power.
Using the Dispenser Without the Water Filter
Changing the Light Bulbs
You can run the dispenser without a water filter. Your water will not
be filtered.NOTE: Not all bulbs will fit your refrigerator. Be sure to replace the
bulb with one of the same size, shape, and wattage.
1. Remove the base grille water filter.
1. Unplug refrigerator or disconnect power.
2. Slide the cap off the end of the filter.
2. Remove the bulb from behind the control panel in the
IMPORTANT: Do not discard the cap. It is part of your
refrigerator or from behind the light shield in the freezer (on
refrigerator. Keep the cap to use with the replacement filter.
some models). Replace it with a bulb of the same wattage.
3. Insert the cap all the way into the base grille.
3. Plug in refrigerator or reconnect power.
4. Rotate the cap until it is firmly in place.
12WARMERWARMERRREFRIGERATOREFRIGERATORWARMERWARMER1FREEZERFREEZER2RECOMMENDED SETTINGRECOMMENDED SETTING433
REFRIGERATOR CARE4533COOLERCOOLERRECRECOMMENDED SETTINGOMMENDED SETTINGALLOW 24 HOURS BETWEEN ADJUSTMENTSS BETWEEN ADJUSTMEALLOW 24 HOURNTSCOOLERCOOLER5
Cleaning
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
Both the refrigerator and freezer sections defrost automatically.
However, clean both sections about once a month to prevent
odors from building up. Wipe up spills immediately.
IMPORTANT: Because air circulates between both sections, any
odors formed in one section will transfer to the other. You must
thoroughly clean both sections to eliminate odors. To prevent
odor transfer and drying out of food, wrap or cover foods tightly.
10 |
ACEC
