Installation Instructions cont.
NOTE: Do NOT plug power supply cord into outlet.
8.Connect 1/4" spout tubingNOTE: If you need to remove tubing,
(longer tubing) to the rear quicpush dok-wn on collet. Pull tubing out
connect fitting on top of tank.of quicPushk-connect fitting.
tubing straight into fitting as far as it
quick-will go. Pull on tubing. The tubing
should not come out when properlyconnect
fitting
installed.
colletDo Not lengthen, twist or tightly
bend tubing.
9.Connect clear tubing from spout
to center tank tubing using clamp.
Make sure clear tubing does not kink.
clamp
clear
tubing
10.Install saddle valve folloDrwingill a 1/4" hole into water supply line
kit instructions. If water supply line isfor the saddle valve piercing pin.
not copper, shut off water supply and
drain line.
11.Turn saddle valve handlePlace a bucket under open end of
clockwise until lance pierces softwater supply line. Turn on main water
copper tubing and valve is firmlysupply valve to pressurize cold waterclosed
seated. If the water line is not copperline. Chec,k for leaks.
turn the saddle valve handle
clockwise until the valve is firmly
seated. The valve is now in the
closed position.
12.Slowly open saddle valve and
flush line into bucket to remove anyopen
foreign material that may have been
trapped in the supply line during
saddle valve installation.
Close saddle valve.
8 |
ACEC
