COOKTOP CARTRIDGES, CONT.
celain finish may chip without a pancartridge until the tubes and ignitors
to absorb the heat from the burnerstart to engage, then lower the cartridgeNOTES:
flame.so that it rests on the cooktop surface.YA properly adjusted burner with clean
Gently slide forward to fully engage.ports will light within a few seconds.
Although the burner grates are durable,
If using natural gas, the flame will be
they will gradually lose their shine and/or
blue with a deeper blue inner cone.
discolor, due to the high temperatures of
the gas flame.If the burner flame is yellow or is
noisy, the air/gas mixture may be in-
correct. Contact a service technician
to adjust. (Adjustments are not cov-
ered by the warranty.)
TO REMOVE SEALED BURNER
With LP gas, some yellow tips on the
CARTRIDGE:
flames are acceptable. This is normal
1. Control knobs should be in the OFFand adjustment is not necessary.
position and the cooktop should be
YWith some types of gas, you may hear
cool.
a popping sound when the surface
INSTALLATION
2. Lift up the edge of the cartridge untilburner is turned off. This is a normal
the bottom of the cartridge clears the
TO INSTALL SEALED BURNERoperating sound of the burner.
basin. (Lifting the cartridge too high
CARTRIDGE:
YIf the control knob is turned very
while still engaged could damage the
1. Be sure control knobs are turned OFF.quickly from hi to lo, the flame may
ignitor rods and mixer tubes.)
go out, particularly if the burner is
2. Clean basin of any grease accumulation.
3. To disengage the cartridge, hold by thecold. If this occurs, turn the knob to
(See appliance Users Guide for clean-
sides and pull away from the terminalthe OFF position, wait several sec-
ing recommendations.)
receptacle and orifices. Lift out whenonds and relight the burner.
3. With the back raised, position thefully unplugged.
YTo improve cooking efficiency and to
burner cartridge with the mixer tube
4. Do not stack cartridges where they may
prevent possible damage to the
openings and ignitor rods toward the
fall or be damaged.
cooktop or pan, the flame must be
orifices and terminal receptacle. Slide the
adjusted so it does not extend be-
yond the edge of the pan.
5 |
ACEC
