Installation Instructions cont.
13.Connect water supply line fromThe tubing should not come out when
saddle valve to spout copper tubing withproperly installed. Turn the saddle valve
water supplythe factory-assembled quick-connecthandle counterclockwise to open
linefitting. Push water supply line tubingwater line.
quick-connectstraight into fitting as far as it will go. Pull
fittingon tubing.
copper
tubing
saddle
valve
NOTE: Do NOT plug power supply cord into outlet.
14.Turn Temperature Control
counterclockwise to OOff� position.
On
15.Push down and turn the
On/Off Cap clockwise to open spout.
Hold cap open to fill tank (about 1
minute). When tank is full, water will
flow from spout. Release cap.
NOTE: Turn Temperature Control topower supply cord is connected,
OOff� position before plugging hotthe heater will overheat causing
water dispenser into power supplan unpleasant tastey., black specks
If tank is empty and thermostat isin the water, and permanent
in an OOn� position when thedamage to the heater seals.
16.Plug power supply cord intohot water flow from the faucet. This is
grounded outlet.normal for the initial heat-up of the
dispenser.
Turn Temperature Control clockwise
to highest position.Turn Temperature Control to lower
temperature setting if you notice
Water in tank will reach maximum
temperature in approximately vapor or hear boiling noise.
15 minutes.NOTE: Temperature Control
controls tank heater, not water
When water is heating, you may hear
gurgling noises coming from the tank.delivery. Rotate Temperature
There may also be some spitting or Control clockwise to raise water
temperature, countercloise tockw
9lower water temperature. |