Electrical ConnectionStorage Drawer (select models)
Appliances which require electricalCAUTION
power are equipped with a three-
prong grounding plug which must beDo not store plastic, paper products, food or flammable
plugged directly into a properly groundedmaterials in this drawer. The drawer may become too warm
for these items when the oven is in use.three-hole 120 volt electrical outlet.
The storage drawer can be removed to allow you to cleanAlways disconnect power to appliance before servicing.
The three-prong grounding plug offers protection againstunder the range.
shock hazards. DO NOT CUT OR REMOVE THE THIRDTo remove:
GROUNDING PRONG FROM THE POWER CORD PLUG.
1. Empty drawer and pull out to the first stop position.
If an ungrounded, two-hole or other type electrical outlet is
2. Lift up the front of the drawer.
encountered, it is the personal responsibility of the
3. Pull out to the second stop position.appliance owner to have the outlet replaced with a
properly grounded three-hole electrical outlet.4. Grasp sides and lift drawer up and out.
To replace:
1. Fit the ends of the drawer glides into the rails in the range.
Removal of Gas Appliance
2. Lift up the front of the drawer and gently push in to theGas appliance connectors used to connect this appliance to
first stop position.the gas supply are not designed for continuous movement.
Once installed, DO NOT repeatedly move this gas appliance3. Lift drawer up again and push until drawer is closed.
for cleaning or to relocate. If this appliance has to be moved
and/or removed for servicing, follow the procedure described
in the installation instructions. For information, contact
Oven Bottom
Protect oven bottom against spillovers, especially acidic orCustomer Assistance at 1-800-688-1120 USA and Canada.
To prevent range from accidentally tipping, range must besugary spills, as they may discolor the porcelain enamel. Use
secured to the floor by sliding rear leveling leg into the anti-the correct pan size to avoid spillovers and boilovers.
tip bracket.
Conventional Surface Burners
(select models)
Under no circumstances are the surface burner assemblies to
be taken apart for cleaning. The surface burner assembly can
be removed to clean the burner box area.
Freestanding range only:
The two surface burner assemblies are secured in place
during transportation with screws. Once the range is installed,
these screws may be removed to allow quick and easy
removal of the burner assemblies.
To remove:
Allow the burner assembly to cool. Lift up cooktop. Grasp the
burner assembly and rotate it slightly toward the left to
release the two tabs on the assembly. Then lift the assembly
and pull toward the back of the cooktop until the air shutter
ends on the assembly release from the valves.
To replace:
Insert the air shutter ends on the burner assembly over the
valves and lower the assembly into place. Be sure to secure
the two tabs on the burner assembly into the two slots on the
burner support bracket which is mounted to the burner
bottom. (NOTE: If the tabs are not properly inserted into the
slots, the assembly may rock and the burners may not light
properly.)
9 |
ACEC
