Electrical Requirements
GROUNDING INSTRUCTIONS
WARNING
 For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
Electrical Shock Hazardmust be plugged into an outlet that is properly installed
and grounded.
Plug into a grounded 3 prong outlet.
WARNING: Improper use of the grounding plug can
Do not remove ground prong.
result in a risk of electric shock. Consult a qualified
Do not use an adapter.electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
Do not use an extension cord.
the microwave oven is properly grounded.
Failure to follow these instructions can result in death,
Do not use an extension cord. If the power supply cord is
fire, or electrical shock.too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
Observe all governing codes and ordinances.
SAVE THESE INSTRUCTIONS
Required:
 A 120 Volt, 60 Hz, AC only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.
Recommended:This device complies with Part 18 of the FCC Rules.
 A time-delay fuse or time-delay circuit breaker.
 A separate circuit serving only this microwave oven.
Settings
ClockControl Lock
12-hour (12:00-11:59). Activate to avoid unintended start. Depending on your model, the
padlock graphic on the control panel is next to either the Start
To Set Clock:
control or Cancel control. Touch and hold the appropriate control
1. Touch CLOCK.
pad for about 5 seconds until 2 tones sound and padlock icon
2. Enter time.appears in the display. Repeat to unlock control.
3. Touch CLOCK or the Start control.
Tones
Timer
Programming tones and signals. Touch and hold number pad ?1?
Timer can be used independently during any cooking program. for about 5 seconds to turn off programming tones. Repeat to turn
back on. Touch and hold number pad ?2? for 5 seconds to turn off
To Set Timer:
all tones. Repeat to turn back on.
1. Touch the Timer control.
2. Enter time.Demo Mode
3. Touch the Timer control or the Start control.Activate to practice using the control without actually turning on
the magnetron. Touch and hold the Timer control for 5 seconds.
Vent Fan
The ?d? will appear in the display. Repeat to exit Demo Mode.
High, low and off. Comes on automatically as cooling fan during
any cook function.
Features
Cooking Rack (on some models)Progress Bar (on some models)
Use only for 2-level cooking. To avoid damage to the microwave The progress bar is a visual picture of the estimated running time of
oven, always remove rack after 2-level cooking. To avoid damage sensor functions.
to the microwave oven due to soil buildup, clean rack supports
often.6th SENSE? System (on some models)
A sensor in the microwave oven detects moisture released from
Turntable
food as it heats, and adjusts the cooking time accordingly.
Turntable may be turned off (on some models) for manual cooking
?
only. This is helpful when cooking with plates that are bigger than ACCUWAVE Technology (on some models)
the turntable, or when cooking with plates that are side by side. This microwave system delivers a constant stream of the selected
Turntable cannot be turned off during preset or sensor (on some microwave power, whereas typical microwave systems deliver only
models) functions.intervals of 100% and 0% power
Easy Minute Feature (on some models)
Easy Minute feature pads (?1? through ?5?) will start the microwave
oven at 100% power for the selected number of minutes.
3 |
ACEC
