Make sure the bottoms of pots and pans are clean and dry To Replace:
before using them. Residue and water can leave deposits 1. Line up openings in the burner bowl with the coil element
when heated.receptacle.
Do not cook foods directly on the cooktop.
Hot Surface Indicator Light (under ceramic glass)
The hot surface indicator light will glow as long as any surface
cooking area is too hot to touch, even after the surface cooking
area(s) is turned off.
2. Holding the coil element as level as possible, carefully push
coil element terminal into the receptacle.HOT SURFACEHOT SURFACE
3. When the terminal is pushed into the receptacle as far as it
will go, push down the edge of the coil element opposite the
receptacle.
Coil Elements and
Burner BowlsLift-up Cooktop
(on some models)
(on some models)
The lift-up cooktop provides easy access for cleaning beneath.
Be careful not to drop the cooktop. Damage could occur to the
Coil elements should be level for optimal cooking results. Burner finish and the cooktop frame. For more information, see the
bowls, when clean, reflect heat back to the cookware. They also ?General Cleaning? section.
help catch spills.
Cookware should not extend more than 1 in. (2.5 cm) over the To Lift:
coil element. If cookware is uneven or too large, it can produce 1. Lift the cooktop by both front corners until the supports lock
excess heat causing the burner bowl to change color. For more into place.
information, see the ?General Cleaning? section.
Before removing or replacing coil elements and burner bowls,
make sure they are cool and the control knobs are off.
To Remove:
1. Push in the edge of coil element toward the receptacle. Then
lift it just enough to clear the burner bowl.
To Replace:
1. Lift the cooktop from both sides while pressing the support
rods back to unlock them.
2. Pull the coil element straight away from the receptacle.2. Slowly lower the cooktop into place.
3. Lift out the burner bowl.
9 |
ACEC
