132993390_GB.qxd 10/18/02 12:10 PM Pagina 7 (Nero/Process Black pellicola)
Installation
Unpacking6. Plug all the holes with the plugs which you will
find in the envelope containing the instruction
All transit bolts and packing must bebooklet.
ENGLISHremoved before using the appliance.
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
1. Using a spanner, unscrew and remove the two
rear bottom screws. Slide out the two plastic pins.
Lay the machine on its back, taking care not to
squash the hoses. This can be avoided by
placing one of the corner packing pieces betweenPositioning and levelling
the machine and the floor.Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar
materials under the machine to compensate for any
unevenness in the floor.
2. Remove the polystyrene block from the bottom of
the machine and release the two plastic bags.
Water inlet
3. Very carefully slide out the left polythene bag,Connect the water inlet hose supplied with the
removing it towards the right and thenmachine to a tap with a 3/4" thread.
downwards.
4. Very carefully slide out the right polythene bag,Do not use already employed hoses for water
removing it towards the left and then upwards.connection.
The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.
5. Set the machine upright and remove the
remaining rear screw. Slide out the relevant pin.
7 |
ACEC
