Using the Tuner Function
The 708II incorporates an auto-chromatic tuner for bass. To use the tuner function, the built-
in effects must be bypassed (temporarily turned off) or muted (direct sound and effect sound
turned off).
1.To set the 708II to the bypass (mute)The note is shown on the left part of
condition, press and release boththe indicator
[W]/[Q] foot switches in play mode. ADG
When you press and immediately release both
ADG
foot switches, the 708II goes into bypass mode.
BE
CF
Release immediately
CF
A8
BYPASS**Pitch is sharp Correct pitch Pitch is flat
While the 708II is in the bypass condition, all
effects are off and only the direct sound is
ListeningtoPatches(PlayModeOperation)
output. The expression pedal works as a volume
The more the pitch is off,
pedal.
the faster the indicator rotates
To the right of the note, a symbol indicates
When you press and hold both foot switches for
by how much the tuning is off.
at least 1 second and then release them, the
708II goes into mute mode.
3.To change the reference pitch of the
Press and release tuner, use the TYPE [W]/[Q] keys.
after at least 1 second
The current reference pitch is briefly shown on
the display. The default setting after power-on is
center A = 440 Hz.
MUTE* *440HZ
Reference pitch value
While the 708II is in the mute condition, there is
no sound output from the [OUTPUT/PHONES]
jack. 4.While the reference pitch is shown,
you can change the pitch by pressing
2.Play the open string you want to tune. the TYPE [W]/[Q] keys.
The [BANK/PATCH] indicator shows the noteThe available setting range is 435 � 445 Hz in
which is closest to the current pitch. Tune your1-Hz steps. When the 708II is turned off and on
instrument until the note indication shows theagain, it will be reset to 440 Hz.
desired note.
5.Press one of the [W]/[Q] foot switches.
The 708II returns to the play mode.
ZOOM 708II BASS11 |
ACEC
