ELECTRONIC OVEN CONTROL
To Set:
4123
Before setting, make sure the oven, TIMER and COOK TIME are off.
1. Press CLOCK.
2. Press the HR or MIN ?up? or ?down? arrow pads (buttons) to
set the time of day.
3. Press CLOCK or START.
Tones
Tones are audible signals which indicate that a function has been
entered correctly, or when a cycle has ended.
1. Convection Controls (on convection models only)
To shut off all tones except the end-of-timer and error
2. Self-Clean Control (on self-clean models only)
tones:
3. Electronic Display
4. Light Controls (on some models)1. Press and hold the STOP TIME button for 5 seconds.
2. A short tone will sound when the tones have been changed.
To turn tones back on, repeat step 1.
Display3. ?Off? will be displayed for 3 seconds when the tones have
been turned off, and ?ON? will be displayed for 3 seconds
When power is first supplied to the appliance, everything on the
when the tones have been turned back on.
display will light up for 1 to 2 seconds, then a time of day and
?PF? will appear. Press OFF to clear ?PF? from the display. To choose between high and low volume tones:
1. Press and hold the DELAY button for 5 seconds.
If ?PF? appears at any other time, a power failure has occurred.
Press OFF and reset the clock if needed.2. A short tone will sound indicating the tones have been
When the oven is in use, the display shows preheat time and the changed.
temperature and oven setting.3. Either ?HI? or ?Lo? will appear on the display for 3 seconds to
show the volume you have chosen.
When the oven is not in use, the display shows the time of day.
When using the TIMER, for settings of 1 to 59 minutes, the
display will count down in seconds. For settings 1 hour or over, Timer
the display will count down hours and minutes.
The Timer can be set in hours or minutes up to 12 hours and 59
When using COOK TIME, the display will show hours and
minutes, and counts down the set time.
minutes. When using STOP TIME, the display will show minutes
NOTE:
and seconds.
The Timer does not start or stop the oven.
StartTo Set:
After setting a function, you must press the START button to start 1. Press TIMER SET.
the function. If you do not press the START button within 5 If no action is taken after one minute, the display will return to
seconds, ?START?? will be displayed as a reminder.the time of day mode.
2. Press the HR or MIN ?up? or ?down? arrow pads (buttons) to
Offset the length of time.
The OFF button stops any function except the Clock, Timer and 3. Press START.
Control Lock. When you press the OFF button, the display will If not pressed within 5 seconds, the display will return to the
show the time of day, or the time remaining if the TIMER is being time of day mode and the programmed function will be
used.canceled.
When the set time ends, end-of-cycle tones will sound, then,
if on, reminder tones will sound every minute.
Clock
On some models, if you do not want the clock time to be 4. Press TIMER OFF anytime to cancel the Timer.
displayed, press and hold the CLOCK pad (button) for 5 seconds. Remember, do not press the OFF pad (button) because the
When the clock is not displayed, you can see the time for 5 oven will turn off.
seconds by pressing the CLOCK pad (button).
To display the time of day when the timer is counting down, press
CLOCK.
10 |
ACEC
WHIRLPOOL
