PHILIPS 28PW9618/05 Instruction Manual

2209.1 gb 11-02-2003 10:17 Pagina 16
Dual screen / PIP / Multipip
Press the b key to switch on Dual screen,PIP or one of the PIP modes.
Press the b key again.The screen that has a yellow border will become
Bthe full main screen picture.
VCR DVD SAT AMP CD
Notes:

vSelect- Continuing to hold the b key down will cycle the TV through the various
O!Aformats launching a new format after each second the key is held down.After
?
standby of the TV,the preference as set in the Setup,General menu is used.
ab- When Dual screen mode is selected,two picture formats are supported:Full
?
screen or 4:3 letterbox picture format (vertical squeeze).
?OK?- Audio from the right screen or the PIPplays to the headphones.
?
SMENU
Display options
++
V?PDual screenPIPPIP 3PIP 12
--
AUXPIP1PIP1 PIP2 PIP3PIP4
123AUXPIP2PIP5 PIP6 PIP7PIP8
PIP3PIP9 PIP10 PIP11 PIP12
456
789
- Press the cursor right to highlight the right screen.
i00- Press the cursor down to highlight the single PIP screen.
bActive Control- Press the cursor right to enter the Multipip screen and then use the
bhq
cursor keys to navigate through the PIP screen and to highlight a PIP
screen.
Changing TV channels or external sources in left, right, PIP or
Multipip screen
Press the -P+ key, the 0 key or the digit keys in order to change the
TV channels or external sources in the highlighted screen.
Scan PIP3 or PIP 12
Navigate to the lowest PIP to display and press the cursor down to
display a following series of PIP screens.
Define the position and the size of the single PIP screen
&Select a Dual screen mode with a single PIP screen.
o
éPress the cursor down to highlight the PIP screen.
S
A PIP menu appears with which you can define the position and the
Positionsize of the PIP screen.
SizeNote:When the PIPmenu timed out,press the OKkey to make it reappear.
Press the cursor down again to select Positionor Size.
Press the OKkey or the cursor right to activate.
(Use the cursor keys to define the position of the PIP screen.
Use the cursor left/right to define the size of the PIP screen.
§Press the OKkey.The PIPmenu reappears.
eNavigate to the top of the menu to highlight the main screen again.
!Press the OKkey to switch off the menu or wait until it is timed out.
On-Screen information
The highlighted On-Screen information,which appears when changing
channels, always refers to the active screen.
16