IMPORTANT SAFETY INSTRUCTIONS
WARNING FOR YOUR PROTECTION
CAUTIONPLEASE READ THE FOLLOWING:
RISK OF ELECTRIC SHOCKKEEP THESE INSTRUCTIONS
DO NOT OPEN
ATTENTION: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIRHEED ALL WARNINGS
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRICFOLLOW ALL INSTRUCTIONS
SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE
CLEAN ONLY WITH A DAMP CLOTH.
The symbols shown above are internationally accepted symbols that warn of
potential hazards with electrical products. The lightning flash with arrowpoint
DO NOT BLOCK ANY OF THE VENTILATION OPENINGS. INSTALL IN
in an equilateral triangle means that there are dangerous voltages present
within the unit. The exclamation point in an equilateral triangle indicates thatACCORDANCE WITH THE MANUFACTURERS INSTRUCTIONS.
it is necessary for the user to refer to the ownerOs manual.
DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS,
These symbols warn that there are no user serviceable parts inside the unit.HEAT REGISTERS, STOVES; OR OTHER APPARATUS (INCLUDING
Do not open the unit. Do not attempt to service the unit yourself. Refer all
AMPLIFIERS) THAT PRODUCE HEAT.
servicing to qualified personnel. Opening the chassis for any reason will void
the manufacturerOs warranty. Do not get the unit wet. If liquid is spilled on
ONLY USE ATTACHMENTS/ACCESSORIES SPECIFIED BY THE MAN-
the unit, shut it off immediately and take it to a dealer for service. Disconnect
UFACTURER.
the unit during storms to prevent damage.
UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN
UNUSED FOR LONG PERIODS OF TIME.
SAFETY INSTRUCTIONS
WATER AND MOISTURE: Appliance should not be used near water
NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER CORD.(e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet
basement, or near a swimming pool, etc). Care should be taken so
WARNING: THIS APPLIANCE MUST BE EARTHED.
that objects do not fall and liquids are not spilled into the enclosure
through openings.
The cores in the mains lead are coloured in accordance with the following code:
GREEN and YELLOW - Earth BLUE - Neutral BROWN - LivePOWER SOURCES: The appliance should be connected to a power
supply only of the type described in the operating instructions or as
As colours of the cores in the mains lead of this appliance may not correspond with
marked on the appliance.
the coloured markings identifying the terminals in your plug, proceed as follows:
Y The core which is coloured green and yellow must be connected to the ter-GROUNDING OR POLARIZATION: Precautions should be taken so
minal in the plug marked with the letter E, or with the earth symbol, orthat the grounding or polarization means of an appliance is not
coloured green, or green and yellow.
defeated.
Y The core which is coloured blue must be connected to the terminal marked
N or coloured black.
POWER CORD PROTECTION: Power supply cords should be routed
Y The core which is coloured brown must be connected to the terminal
marked L or coloured red.so that they are not likely to be walked on or pinched by items placed
upon or against them, paying particular attention to cords at plugs,
This equipment may require the use of a different line cord, attachment plug, or
convenience receptacles, and the point where they exit from the
both, depending on the available power source at installation. If the attachment
appliance.
plug needs to be changed, refer servicing to qualified service personnel who
should refer to the table below. The green/yellow wire shall be connected direct-
ly to the units chassis.SERVICING: To reduce the risk of fire or electric shock, the user
should not attempt to service the appliance beyond that described in
the operating instructions. All other servicing should be referred to
WIRE COLOR
CONDUCTORqualified service personnel.
NormalAlt
LLIVEBROWNBLACKFOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE
RECEPTACLE: Replace fuse with same type and rating only.
NNEUTRALBLUEWHITE
E EARTH GND GREEN/YELGREEN
MULTIPLE-INPUT VOLTAGE: This equipment may require the use of
a different line cord, attachment plug, or both, depending on the
available power source at installation. Connect this equipment only to
WARNING: If the ground is defeated, certain fault conditions in the unit or in thethe power source indicated on the equipment rear panel. To reduce
system to which it is connected can result in full line voltage between chassis andthe risk of fire or electric shock, refer servicing to qualified service
earth ground. Severe injury or death can then result if the chassis and earth
personnel or equivalent.
ground are touched simultaneously. |
ACEC
HARMAN
