Be sure to use the foam blocks that are provided.
See Figure above. (CAUTION: BE SURE CABINET
DOES NOT FALL OUT OF WINDOW.)
_I
LEFT RIGHT
FILLER FILLER
BOARD BOARD
WINDOW
CHANNEL
i
i D
8. Apply seal strips and attach filler boards. De-
termine which will be your left and right filler
boards The holes on each board should align
with the holes in the side mounting angles. Each
filler board should also extend about l/2? above
the top edge of the air conditioner cabinet. Now
apply the 3/s?-wide seal strips on the roomside of
each filler board as shown (I.e. along the bottom
edge and window channel edge). Also place a
seal strip along the top outside edge of each filler
board. Now attach the filler boards to the side
mounting angles with four. 3/e?, round- headed
sheet metal screws. Tighten the screws only
loosely, so the filler boards can be moved back
and forth.
9. Insert side mounting slides all the way into top
mounting channel.
THE FOAM BLOCKS
- PROVIDED ARE TO HOLD
FILLER BOARD TIGHT
AGAINST WINDOW CHANNEL
0 f)-- CUT EL;;;,? ;Lh?,?,HW?DE?
THAN CHANNEL AND WEDGE
? WINDOW ; WINDOW
! CHANNEL CHANNEL
11 Lower window and level air conditioner. Lower
the window firmly behind the top mounting
channel. Leveling the cabinet is not required in a
normal installation since the proper slope IS
10 Place cabinet in window by turning cabinet to designed into the product. However, be sure you
one side to get one filler board Into window have approximately a one-half bubble (38?)
channel. Now maneuver other filler board into downward tilt to the outside for proper water
other window channel. Reaching through win- drainage. If necessary, reposition or shim cabinet
dow opening, push filler boards from outside as to provide the proper tilt or side-to-side leveling.
far toward you as they will go. Extend the Now tighten all four filler-board screws. Finally,
mounting slides outward into the window chan- make two 3132? pilot holes into the window sill.
nels on both sides. Pull the cabinet toward you to using the holes in the cabinet as a guide. Use two
position the side mounting slides as far forward wood screws to secure the bottom of the cabinet
In the window channels as possible. Now mark to the window sill.
and make a 3 X? pilot hole for each wood screw
IuSed to secure the slides in the window channels.
13 |
ACEC
WHIRLPOOL
