g
Operating multifunction sectionCitrus press
0 Open cover (fig. 1/F) and place all
(Food Processor 750 only)
ingredients required in the all-purpose
bowl.
Caution: Do not exceed maximum fill-Preparation (fig. 13)
ing volume:
0 Fit all-purpose bowl as described above
- liquid 1.75 litres
(fig. 5).
- solid 1.5 litres
0 Place sieve insert of citrus press (fig.
Further ingredients can be added dur-13/a) on all-purpose bowl (arrow
3
ing operation through the filling inlet. on arrow ) and turn cunter-clock-
The filling beaker in the stopper (fig. wise to the stop. The sieve insert can
1/E) can also be used for this purpose. be heard to engage, arrow must
Close the filling inlet immediately each coincide with arrow .
time to avoid splashes.
0 Insert press cone (fig. 13/b) in sieve
Use the stopper exclusively to com-insert.
1
press the cutting items!
0 Start the appliance: turn speed selector Operating citrus press
(fig. 1/l) right to the desired speed set-
0 Start appliance: turn speed selector
ting or press the pulse button (fig. 1/J).
(fig. 1/J) right to position 1.
It is recommended to start at a slow
3The citrus press must only be operated
speed and then to increase the speed. 3
at the lowest speed.
The appliance operates at maximum
0 Switch off appliance: turn speed selec-
speed by pressing the pulse button.
tor left to the "0" position.
Refer to the section "Tips on using
multifunction section" for reference 0 Remove press cone after use.
values.0 Turn sieve insert clockwise and remove.
0 Turn all-purpose bowl clockwise and
If the warning lamp (fig. 4/a) flashes
1
remove.
and the appliance cannot be started,
the safety cover for the mixer drive
The appliance can be used for up to
1
(figs. 1/S and 4) is not properly fitted.
10 minutes without stopping. It should
0 Switch off appliance: turn speed selec-be allowed to cool each time following
tor left to the "0" position.prolonged, continuous operation (for
0 After using, turn cover clockwise and at least 20 minutes after using for
remove.10 minutes without stopping).
Only remove the cover when the tool
1
has come to a complete stop!Cleaning and care
0 Remove the tool and spindle.
0 Turn the all-purpose bowl clockwise
Motor casing
and remove.
Ensure that no liquid enters the motor
1
casing!
0 Clean the motor casing with a moist
cloth. Never immerse in water or hold
under running water!
62 |
ACEC
ELECTROLUX
