Troubleshooting
Removing Misfed Paper
When a paper misfeed occurs, an er-r Make sure the size of the paper
ror message appears on the panel dis-loaded in the paper tray is same as
play. The procedure you shouldthe size of the OHP transparency.
follow to remove the misfed paperr If misfeeds persist, contact your
depends on its location which is indi-
cated on the panel display.sales or service representative.
r Do not touch the photoconductor
R CAUTION:unit when removing misfed paper.
?When removing misfed pa-If you do, the photoconductor unit
per, do not touch the fusingmi ght be damaged.
r Exposing the photoconductor unitsection because it could be
to light for too long can reduce itsvery hot.
?When accessing the inside of performance. Close the cover as
the machine, do not touch any quickly as possible.
sections other than those rAfter removing the misfed paper,
specified in this manual. If youthe bac k sides of the next printout
do, it might result in receivming ight get dirty. Print a few pages
a burn or injury.to absorb the toner.
6
Important
r If your printer is equipped with
the optional tray, do not pull out
more than one tray with paper at a
time. If you do, the printer might
tilt forward.
r Check the following points if pa-
per continues to misfeed.
? Make sure paper is properly
loaded in the paper tray.
? Make sure the number of sheets
do not exceed the maximum ca-
pacity of the tray.
? Make sure you are using only
the appropriate type of paper.
? Make sure misfed paper is still
not inside the printer when you
resume printing.
? Check the paper type settings.
The type of paper set with the
printer driver might be different
from the actual paper or media
type. Make the correct paper or
media type setting.
76 |
ACEC
RICOH
