Parts and their function
Rotary head connector panel
@ ND/EXT connector [ND/EXT]B LENS P/S ON/OFF switch [LENS P/S]
This is for the control of the ND filter and lens extender of When this is set to ON, power is supplied to the lens from
the motorized lens unit.the LENS I/F (1) connector. When it is set to OFF, power
Connect this connector when using a motorized lens is no longer supplied to the lens from the LENS I/F (1)
unit with ND filter and lens extender functions. The cable connector.
described in Cable specifications on page 6 is required Set this switch to OFF when power is to be supplied from
in order to connect this connector.a source outside the unit without using the AW-PH405s
dedicated camera cable.
CanonEXT (s )CVCC (12 V)
C LENS I/F (1) connector [LENS I/F (1)]
CanonEXT (r )CGNDThis is used to control the zooming and focusing of the
motorized lens unit.
ND SignalEXT ReturnUse the motorized lens units remote (zoom/focus) control
ND ReturnEXT Signalcable to make the connection.
(Pin layout as seen from cable end)D CAMERA I/F connector [CAMERA I/F]
This is used for the control of the convertible camera.
The current rating of the CVCC and CGND pins is Use the camera cable supplied with the AW-PH405 to
500 mA (max). Any devices whose maximum current connect the connector with the REMOTE connector on
consumption exceeds 500 mA cannot beused.the camera.
Depending on the functions of the optional card, a special
A LENS I/F (2) connector [LENS I/F (2)]camera cable (sold separately) is required.
This is used when an IAS, WAS or VAS lens made by
Canon or an RD lens made by Fujinon is to be used.E SDI IN connector [SDI IN]
The optional connecting cable is required to connect the Use a coaxial cable to connect this to the SDI OUT
lens with the connector.connector on the AW-PB504 SDI card or other card
The current rating of LENS I/F () connector is 500 mA installed in the convertible camera.
(max).
The lens whose maximum current consumption exceeds F AUX IN connector [AUX IN]
500 mA cannot be used. Concerning the maximum This connector is connected using a BNC coaxial cable
current consumption of the lens, contact the lens to the SDI OUT connector on the AW-PB504 SDI card
manufacturer.or other card installed in the convertible camera or to the
VBS connector on the AK-HDC1500G down converter
board or other board installed in the AK-HC1500G
LensCable
Canonmulti-purpose camera.
DigitalAW-CA4DLZGG TALLY OFF/ON switch [TALLY]
AnalogAW-CA4ALZGWhen this is set to ON, the tally lamp is lighted by the
FujinonAW-CA4FLZGselected signals. When it is set to OFF, the (6 ) tally lamp
will not light even if the selected signals are supplied.
Note3 Refer to the instructions for using the
connecting cable to ensure that it is
connected properly.
9 |
ACEC
PANASONIC
