XP AZ 1140/17 02-02-2000 11:53 Pagina 10
AZ 1140 /17 page 10
BASIC FUNCTIONSGENERAL INFORMATION
Switching on and off
Y Adjust the POWER slider to the desired sound source:
EnglishCD, TUNER or TAPE/OFF.CDTUNER
FFOTAPEBLOVAWOLTT
Y The set is switched off when the POWER slider is in theDYBNAASMSICDBB
BOOST
TAPE/OFF position and the keys on the tape deck are released.PAUSESTOPYOPENSEARCH
PLAYYPAUSEPLAYRECORD
" The volume and tuner presets will be retained in the set's
PROGRACMD
memory.REPEAALTL
Adjusting volume and sound
1. Turn the VOL control to increase or decrease VOLUME.
2. Adjust the DBB control to select dynamic bass boost on or off.
CD
TBUATNTER
OTFAFPELOW
DBBVOL
D YB NABOASOMSISCT
PAUSESTOPYOPENSEARCH
PLAYYPAUSEPLAYRECORD
PROGRACMD
REPEAALTL
PHILIPS demo modeDYNAMIC
B BAOSSOST
1. On the set, press the CD STOP 9 button for 5 seconds.PAUSESTOPYOPENSEARCH
PLAYYPAUPLAYRECORD
" PH..IL ..IPS scrolls across the display continuously.SE
PROGRACMD
2. To return to the current display you can either:REPEAALTL
Y press any function button on the front panel. This interruptsESTOCD MODSEARCHP
the demo mode for 30 seconds;PROGRAM
Y press the CD STOP 9 button for 5 seconds. PH..IL ..IPS
scrolls once before the demo mode is cancelled.
GENERAL INFORMATION
General maintenance
Y Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
Y To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the
housing.
Safety information
Y Place the set on a hard and flat surface so that the system
does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.
Y The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
10 |
ACEC
PHILIPS
