2
1
2
To Assemble Bagger
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person when putting the bagger to-
4 geth er.
1. Front bagger tube" Holes in front bagger tube are at an angle. Place front
3025bagger tube against lower bagger tube and check for 92
2. Lower bagger tube
proper hole alignment before assembling bolts.
3. 1/4 x 50,8mm Car riage
" Assemble front and lower bagger tubes using four (4)
Bolts
1/4 x 50,8mm carriage bolts and lock nuts supplied.
4. 1/4 Lock nutTighten se cure ly.
5" Slide front and lower bagger tube assembly into the bag-
ger assemby.
" Assemble front and upper bagger tubes using four (4)
3
1/4 x 50,8mm carraige bolts and lock nuts supplied.
Tighten se cure ly.
" Slip all the vinyl bindings over the bagger tubes
2
" Slide the bagger dump handle through the hole in the
6bagger top, install the clevis pin and secure with retainer
7spring.
8
02593" Push cap over end of bagger dump handle.
NOTE: For future use, the clevis pin may be removed in order
to use the handle to clear the chute in the event it has become
1. Front bagger tube1
clogged.
2. 1/4 x 50,8mm Car riage
Bolts
4Bagger adjustment
3. 1/4 Lock nut
For proper bag function and appearance, it may be nec es -
4. Vinyl Bindingsary to adjust the bagger assembly. There should be 6mm
(1/4")-9mm (3/8") gap between the bagger top and fender and
5. Dump handle tube
6MM (1/4") - 9MM (3/8")the bagger top surface should be even with the top surface
6. Clevis pinof the fender. To adjust bagger position:
7. Retainer spring
8. Cap1Horizontal adjustment
2" Slightly loosen the nuts securing the bagger RH and LH
hor i zon tal adjustment brackets. Loosen only enough so
the brackets keep their position, but allow them to be
moved.
" Move the brackets the amount forward or back ward you
wish the bag assembly to move. Retighten the nuts se-
curely.
3
02329
Vertical adjustment
" Slightly loosen the nuts securing the vertical adjustment
brackets. Loosen only enough so the brackets keep their
position, but allow them to be moved.
1. Top Surfaces Even" Move the brackets the amount up or down you wish the
bag assembly to move. Retighten the nuts securely.
2. Horizontal Adjustment Brack et
" Reinstall the bagger as sem bly and check the bagger to
3. Vertical Adjustment Brack et
fender t. If necessary, repeat the procedure until proper
t is attained.
To convert to bagging, mulching or discharge
See "Sec tion 5" of this manual.
25 |
ACEC
ELECTROLUX
