CHAPTER 3 MECHANICAL SYSTEM
3) While holding the swing guide, insert a
stack of sheets [3], and butt it against the
rear edge stopper [4].
[4][3]
Figure 3-711
4) Slide the stapler holder [6] until the stapler
paper stopper [5] comes into contact with
the stack of sheets; then, loosen the screws.
[6][5]
Figure 3-712
3. Positioning by Stapling
If you are not sure about the index because
of, for instance, the replacement of the stapler
holder and, in addition, the stapler paper stop-
per has moved, perform the following:
1) Release the machine from the copier.
2) Fix the stapler holder to the mount tempo-
rarily. (At this time, try to fit the screw
somewhat on the rear side.)
3) Move the stapler [1] to the center of the
rail.[1] [3][2]
4) Loosen the screw of the stapler paper stop-
per (left, right).Figure 3-713
5) While holding the swing guide, insert a
stack of sheets [2], and butt it against the
rear end stopper [3].
COPYRIGHT ? 1999 CANON INC.CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)3-39 |
ACEC
CANON
