Top Panel Features
MIC Input Section
16. MIC LEVEL Control
MICPGM1PGM2CONTROL
This knob adjusts the gain
OLUSOURCESOURCEUMAIN
of the mic preamp for any SIG48VLINE/LINE/
OFFPHONOPHONOOOOOOO
microphone plugged into the LEVEL+3+50ONLEVELMAXCDCDLEVELMAXLEVELMAX
MIC input jack [1]. It ranges EQEQEQBOOTHU
U
from +13 dB to +63 dB of
HIGHHIGHHIGHSTEREOOOMAX
MONO
gain. Adjust this knob so -15 +15KILL+10KILL+10LEVEL
FX
that the loudest speaking or U
shouting that you do into the MIDMIDMIDOO+15
-15 +15SEND
KILL+10KILL+10
microphone just barely lights
d.2 2-channel DJ MixerU
the OL LED [18]. This gives
LOWLOWLOWOO+15
RETURN
you the best signal-to-noise KILL+10KILL+10-15 +15
PHONESU
ratio for the mic preamp.PGMMAIN
ONFXFXOOMAX
LEVEL
PGM SOURCE
PANBALBAL111
17. MIC SIGNAL LED2
L RLRRL
This green LED is a signal
present indicator. It lights
when the microphone signal
reaches 20 dBu, to give you a clue that the microphone 21. MID EQ
is working.
This knob gives you up to 15 dB of boost and cut at
2.5 kHz. At the center position the MID EQ has no effect
18. MIC OL LED
on the signal.
This red LED lights when the microphone signal
reaches 6 dB below clipping. Its okay if this LED blinks 22. LOW EQ
occasionally, but if it is blinking frequently or lit con-
This knob gives you up to 15 dB of boost and cut at
tinuously, turn down the MIC LEVEL control [16] until
80 Hz and below. At the center position the LOW EQ has
it just blinks occasionally.
no effect on the signal.
19. 48V Phantom Power Switch
23. ON Switch
If your microphone is a condenser design, it probably
Press this switch in to send the microphone signal to
requires phantom power to operate. Push in this switch
the MAIN outputs, otherwise, your dulcet tones will not
to supply 48 VDC to pins 2 and 3 of the XLR microphone
be heard, and people will say huh?
connector.
Dynamic microphones, like Shures SM57 and SM58,
24. PAN
do not require phantom power. However, phantom
power will not harm most dynamic microphones should
This knob adjusts the amount of microphone signal
you accidentally plug one in while the phantom power
that is sent to the left versus the right main outputs.
is turned on. Check your microphones users manual if
When the knob is turned hard left, the signal feeds only
you are not sure whether your microphone needs phan-
the left main out, and when the knob is turned hard
tom power or not.
right, it only feeds the right main out. When the knob is
in the center, the microphone signal is sent equally to
20. HIGH EQthe left and right main mix. The endish design of the
pan circuit allows constant pan power, where the aver-
This knob gives your mic signal up to 15 dB of boost
age audio output level remains constant for all positions
and cut at 12 kHz and above. At the center position the of the PAN control.
HIGH EQ has no effect on the signal.
12d.2 DJ Mixer |
ACEC
MACKIE
