Note: Vapours from the oven vents may in timeTHE COOLING FAN FOR THE CONTROLS
cause discolouration of wallcoverings behind the
appliance. For ease of cleaning it may be preferableThe cooling fan operates immediately when the grill
to tile behind the appliance.or top oven is switched on. It may run on after the
controls are switched off until the appliance has
Overhanging surfaces or a cooker hood should be a
cooled.
minimum of 685mm above the hob.
Note: The action of the cooling fan will depend on
how long the top oven or grill have been used and at
what temperature. It may not run on where the grill
or top oven has been used for a short time or at low
temperatures. Do not switch the appliance off at its
power point until the cooling fan has cooled the
appliance down.
CONTROL PANEL INDICATOR NEONS
These lights indicate whether the ovens are switched
on.
It is important to ensure that the appliance is level
after installation. Levelling feet are fitted to theThe neons also indicate when the set temperature
appliance to accommodate uneven floors.has been reached. They will turn on and off during
use to show that the temperature is being
maintained.
GENERAL NOTES ON USING YOUR
If the neons do not operate as the instructions
APPLIANCE
indicate the controls have been incorrectly set.
We suggest that you run the oven elements for 10 -Return all controls to zero and re-set following the
o
15 minutes at 220C to burn off any residue frominstructions for the required setting.
their surfaces. The procedure should be repeated
with the grill for approximately 5 - 10 minutes.
During this period an odour may be emitted, it is
COOKWARE
therefore advisable to open a window for ventilation.
Baking trays, oven dishes etc., should not be placed
directly against the grid covering the fan at the back
ABOUT CONDENSATION AND STEAMof the oven.
Do not use baking trays larger than 30cm x 35cm
When food is heated it produces steam similar to a
(12? x 14?) as they will restrict the circulation of heat
boiling kettle. The oven is vented to allow some of
and may affect performance.
this steam to escape. However, always stand back
from the appliance when opening the oven door to
allow any build up of steam or heat to release.
If the steam comes into contact with a cool surface
on the outside of the appliance, e.g. a trim, it will
condense and produce water droplets. This is quite
normal and is not caused by a fault on the appliance.
To prevent discolouration, regularly wipe away
condensation and also soilage from surfaces,
including the vent at the rear of the hob. See note at
the top of this page.
For your safety wallcoverings at the rear of the
appliance should be securely fixed to the wall.
8 |
ACEC
ELECTROLUX
