01DVDR980UMUKGB24271F3 21-01-2002 15:24 Pagina 51
Diagnosis programmeSystem limitations
EnglishIf the recorder is still faulty you can start the Diagnosis
Programme in the recorder.DVD+RW and DVD+R discs may not play on certain
DVD Video players.
You can operate the Diagnosis Programme by following
the instructions step by step.A DVD+RW video disc that has been recorded on a
different type or brand of recorder can be played, but
may not provide all features commonly available to
InstructionsDVD+RW discs, such as the on-screen disc bar, the disc
settings menu, the title settings menu, and editing.
Refer to Adapt disc format. If the disc is write-
protected, the status cannot be changed.
When using manual recording, the DVD recorder will
warn before adapting the format of the disc or removing
non-video data. When using timer recording however,
l Unplug the power cord of the recorder.the DVD recorder will always start to record, unless the
l Press the 2 PLAY key and keep them presseddisc is write-protected. Menus, edits and other data
while you plug the recorder.
recorded on a different device (e.g. a PC) may be lost.
0 On the display the message BUSY appears
together with a counter. This counter indicates theBecause of the Variable Bit Rate, a title map take up less
termination of the test when zero is reached.or more space than the overwritten title, even though
0 After a few minutes the message on the localthe duration is the same. As a result, a part of the
display changes over from BUSY to FAIL or to
PASS.original title may remain, or a part of the next title may
be lost. The maximum deviation is five minutes.
0 If the message FAIL appears on the display,
there is apparently a failure in your recorder andAfter a power interruption during recording, the Index
your recorder should be repaired.Picture Screen will may not match with the actual video
l Consult your dealer or the Philips Customer Care
Centre for the nearest Service Repair Shop in yourcontent on the disc. The last recorded title may be lost.
country. The phone number is given in your
warranty booklet.
l If the message PASS appears on the display, there
is apparently no failure in your recorder, in this case
the failure can be caused by incorrect interpretation
of the operating instructions or a wrong disc is used
or your recorder is not correctly connected. In this
case you should consult your dealer or the Philips
Customer Care Centre for further assistance in
solving the problem.
l If the problem remains, then consult your Philips
Customer Care Centre.
TROUBLESHOOTING 51 |
ACEC
PHILIPS
