Digital temperature display
INITIAL START UP
Stick the plug into the socket, then turn the temperature
controller away from the "off" zone, this way the green lamp
showing the energy supply will be on.
- If the temperature adjuster is in the "off" zone and the
plug of the device has been connected to the socket,
the device will not work, neither will the display, and the
control lamps will not be on.
- The device runs in SUPER FROST mode for 5 hours,
the yellow SUPER FROST indicator lamp will be on.
- If you want to stop the SUPER FROST mode, keep
pressing the SUPER FROST button for 2 seconds. At
this time, instead of the "SP" sign, the display will show
the inner temperature, the yellow lamp indicating
SUPER FROST will go out.
All models have a digital temperature display integrated in
the handle of the lid. In normal operation, it shows the
temperature of the frozen products in centigrade (°C).
There are however the following exceptions:
- During fast freezing FROSTMASTIC function ?SP? is
shown.
- If there is a failure of the temperature display, a small
square can be seen in the bottom right or top right
corner. (Also see section "Something Not Working").
The temperature display indicates the temperature of
the frozen food and therefore changes relatively
slowly, if you put fresh goods in for example. If you leave the
lid open for a long time, the temperature warning may
respond, the temperature display may however remain
unchanged. In this case there is no malfunction. Press the
WARNING OFF button, to switch the warning buzzer off. The
red warning light goes out automatically after a short time.
After power-supply failure or when starting up the device
for the first time, the device switches to SUPER FROST
mode for 5 hours, if the temperature in the freezer is too
high. An "SP" sign will appear on the display. If you want
to switch it off before the 5 hours is over, keep pressing
the SUPER FROST button for 2 seconds.
TEMPERATURE WARNING
If the temperature in the freezer is too high, the warning
buzzer sounds and the red warning light flashes.
The warning buzzer and red warning light are triggered:
- if the storage temperature required has not yet been
reached when starting the freezer; if the storage
temperature is no longer maintained (malfunction);
- after inserting fresh foodstuffs in a greater quantity
than permitted by the freezing capacity (see section
on "Freezing";
- if the lid is left open too long.
You can switch off the warning buzzer with the
WARNING OFF button. The red warning light
continues to flash until it is sufficiently cold again
inside the freezer.
The warning buzzer and red warning light are not
triggered:
- if the power supply is interrupted;
- if the electronic thermostat is faulty.
5 |
ACEC
ELECTROLUX
