INSTALLATION INSTRUCTIONS
THINGS YOU NEED TO KNOWa) By connecting to a cooker point (having a double
pole isolating switch with at least 3mm contact
WARNINGS:
separation in all poles and neutral) and protected
This appliance must be installed by a qualifiedwith a fuse or miniature circuit breaker at your
electrician/competent person. Safety may bemains fuse box.
impaired if installation is not carried out in
accordance with these instructions.Subject to Regional Electricity Companies
This appliance must be earthed.regulations if you wish to connect the oven
Do not remove the screws from the earth taband hob to the power supply you may use
extending from the oven mains terminal blockone of the following two methods:-
(Fig. 6).
Before connecting the appliance make sure that
b) By connecting the appliance together with a hob
the voltage of your electricity supply is the same
directly to a cooker point(s). Having a double
as that indicated on the rating plate. This is
pole isolating switch with at least 3mm contact
situated on the lower front frame of the appliance
separation in all poles and neutral.
and can be seen upon opening the main cavity
door. Alternatively the rating plate may also be
c) If you wish to connect an oven and a hob to a
found on the back or top of some models (where
cooker point you can by connecting the oven and
applicable).
hob separately to the cooker point. Oven and
Do not alter the electrical circuitry of this
hob units should be separately connected to a
appliance.
cooker point. See Fig. 1.
THINGS TO NOTE
This appliance is designed to be fitted in cabinets
of the recommended dimensions as shown
(Fig.2).
If your cabinet interior dimension is between 565-
570mm the oven may still be fitted. However, a
minor modification to the cabinet will be required
to reduce the aperture size down to 560-565 mm,
to allow the product to be securely screwed into
the cabinet.Fig. 1
The dimensions given provide adequate air
circulation around the unit within the cabinet,
NOTE: It is good practice to :
ensuring compliance with BS EN60-335.
Fit an Earth Leakage Circuit Breaker to your
Enquiries regarding the installation of the cooker
house wiring.
point, if required, should be made to your
Wire your appliance to the latest IEE regulations.
Regional Electricity Company to ensure
compliance with their regulations.
The cooker socket switch should be outside thePREPARING CABINET FOR FITTING OF OVEN
cabinet but within 2m of the appliance to make it
accessible to switch off the appliance in case of Make sure that the cabinet is the correct size for
an emergency.the appliance to be fitted (Ref. Fig. 2).
To protect the hands, wear gloves when lifting
If the size is between 565-570mm, then the
the oven into its housing.
cabinet should be modified so that at the screw
fixing points the recommended dimension of at
NOTE: HOUSE CIRCUIT
least 560-565mm is maintained. The
Earth leakage and continuity tests must be carriedmodification should ideally be localised to ensure
out before the appliance is connected to the mainsthat after screw fitment the oven is securely
supply and re-checked after fitting.fixed into position.
The cabinet must be stable and level by firmly
GETTING THINGS READY
securing it to the wall or floor. If necessary,
CHOICE OF ELECTRICAL CONNECTIONmake arrangements to ensure the shelf upon
which the oven will rest is level.
There are three possible ways to connect your
appliance. In each case the appliance should be When the appliance is installed ensure a
2
operated using at least 6mm twin core and earthminimum gap of 2mm is maintained between the
PVC insulated multicore cable. Please choosetrim on the bottom edge of the appliance, and
from the most appropriate after reading theany corresponding door / panel underneath.
different methods:-
7 |
ACEC
ELECTROLUX
