Instructions for the installer
The instructions given below areany given point a temperature 50 °C higher
designed specifically for a qualifiedthan the ambient temperature.
installer and should aid him or her toSuitable power supply cables are the
perform all installation, adjustment,following types, considering the respective
and maintenance operations withnecessary section of cable: H07 RN-F, H05
absolute precision and in complianceRN-F, H05 RR-F, H05 VV-F, H05 V2V2-F
with all current legislation and(T90), H05 BB-F.
regulations. We strongly recommend
that all operations for the installationConnecting the terminal board
of your cooker be carryed out by
The appliance incorporates an easily
Qualified Personnel in accordanceaccessible 6-pole terminal board whose
with existing rules and regulations.
jumpers (bridges) are already pre-set for
operation on 400 V tri-phase with neutral wire
Electrical connection(Fig. 8). In case a different mains voltage is
Prior to making the electrical connection,present, the jumpers on the terminal board
must be rearranged as shown in the diagram
make sure that:
(Fig. 9). The ground cable must be
? the protection fuse and the domestic wiring
system are suitable to carry the totalconnected to terminal . After connecting
electric load of the oven (see rating plate);the supply cable to the terminal board,
? your domestic wiring system has ansecure it with a junction clamp.
efficient earth connection in compliance
with rules and laws in force;
? the wall socket or the omnipole switch used
for the electrical connection can easily be
reached after the oven is built in.
This appliance is delivered without an
electric supply cable, therefore, you will
have to fit to it a supply cable with standard
plug, suitable for the total electric load
shown on the rating plate. The plug is to
FO 0330
be inserted into a suitable wall socket. IfFig. 8
you require a direct connection to the
electric network (mains), it will be1 2 3 4 5
230V 3~
necessary to fit between the appliance and
L1 L2 L3 PE
the mains an omnipole switch, with a
1 2 3 4 5
minimum gap between contacts of 3 mm,230V 1~
suitable for the required load and in
L1 N PE
compliance with rules in force. The green &
1 2 3 4 5
yellow ground wire must not be interrupted400V 2N~
by the switch, and should be 2-3 cm longerL1 L2 N PE
than the phase and neutral wires. The supply1 2 3 4 5
cable must in all cases be laid out in such a400V 3N~
way as to ensure that it does not reach atFig. 9FO 0584L1 L2 L3 N PE
30 |
ACEC
ELECTROLUX
