MAINTENANCE AND CLEANING TECHNICAL SPECIFICATIONS
Before any maintenance or cleaning work is carriedChanging the light bulb
out, DISCONNECT the appliance from the
ELECTRICITY supply.Should the interior light fail to work, first switch off
the appliance and disconnect from the electricity
supply, then replace the bulb as follows;DIMENSIONS
Internal cleaning
Height170 cm
Clean the inside and accessories with warm water
and bicarbonate of soda (5ml to 0.5 litre of water).Width55 cm
Rinse and dry thoroughly.
Depth60 cm
NEVER USE DETERGENTS, ABRASIVE
POWDERS, HIGHLY PERFUMEDPOWER SUPPLY VOLTAGE AND FREQUENCY220-240 V / 50 Hz
CLEANING PRODUCTS OR WAX
POLISHES,TO CLEAN THE INTERIOR ASTOTAL POWER ABSORBED110 W
THESE WILL DAMAGE THE SURFACE AND
AVERAGE DAILY UNITS ELECTRICITY *1.2 kWh
LEAVE A STRONG ODOUR.
GROSS CAPACITY
External cleaningFridge 136 l
Unscrew the light cover and then pull it outward by
Many proprietary kitchen surface cleanerspressing as shown in the figure. Unscrew the bulbFreezer143 l
contain chemicals that can attack/damage theand replace it with one of the same power (theNET CAPACITY
plastics used in this appliance. For this reason itmaximum power is shown on the light diffuser)
is recommended that the outer casing of thisavailable from your nearest Service Force Centre.Fridge 134 l
appliance is only cleaned with warm water with a
little washing-up liquid added.Replace the light cover by sliding it into its originalFreezer122 l
position and replacing the screw.
An accumulation of dust will affect the performance
of the appliance and cause excessive electricityDefrosting* This figure is based on standard test results in accordance with European Standard EN 153.
consumption.Actual consumption will depend on how the appliance is used and where it is located.
Refrigerator
You MUST ensure that the appliance is switched
OFF.The refrigerator automatically defrosts every time the
compressor stops. The water is discharged, via the
Once or twice a year dust the condenser (black grill)
pipe, into a tray located at the back of the appliance
above the compressor, where it evaporates.and the compressor at the back of the appliance,
with a brush or vacuum cleaner, see figure.
-
Important
To avoid defrost water overflowing into the fridge,When the appliance is not in use
When the appliance is not in use for long periods,periodically clean the water discharge hole in the
disconnect from the electricity supply, empty allcentre of the V shaped drip collector at the back of
foods and clean the appliance, leaving the doors ajarthe refrigerator compartment behind the fruit and
to prevent unpleasant smells.vegetable drawer. Use the defrost cleaner provided
which you will find already inserted into the
discharge hole.
813 |
ACEC
ELECTROLUX
