To change the light bulb
The light is switched on automatically when theG4UV-blocked
door is opened. Before replacing the light bulb,
disconnect the power plug from the outlet.
Cut the packaging around the bulb socket.
Keep the packaging on to hold the bulb when setting
it into the socket. Do not touch the bulb with your20W/12VLow pressure
bare fingers. Halogen light bulbs are sensitive to
grease from the skin.
Use a clear halogen light bulb.
When the appliance is not in use
Disconnect the appliance from electricity supply.If the cabinet will be kept on, ask somebody to
Empty all foods and clean the appliance, leaving thecheck it once in a while to prevent the food inside
doors ajar to prevent unpleasant smells.from spoiling in case of a power failure.
Something Not WorkingGB
Before contacting your local Service Force Centre check the following point:
ProblemPossible cause / Remedy
It is too warm inside the refrigerator.Set a lower temperature.
Put food products in the right place inside the refrigerator. See
the chapter "Temperature inside the refrigerator".
Distribute the food products to allow cold air to circulate
around them.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
The temperature where the cabinet is placed is above normal
room temperature.
It is too cold inside the refrigerator.Set a warmer temperature.
Vegetables and other products that are easily frozen have been
placed on a "too cold" shelf. See the chapter "Temperature
inside the refrigerator".
There is water on the cooling plate insideThis is normal. During automatic defrosting, frost thaws on the
the refrigerator.cooling plate.
Water is running inside the refrigerator. Clean the water drain and drain hole inside the refrigerator
using e.g. cotton swabs or a bottle cleaner brush.
Some food products could have been placed near the rear of the
appliance prevetung the water from running into the drain.
Water comes out on the floor.Place the drain hose at the back of the cabinet above the drain
bowl. See the chapter "Before using the cabinet the first time".
The compressor operates continuously.Set a warmer temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
The temperature where the cabinet is placed is above normal
room temperature.
The cabinet does not operate at all.The cabinet is not switched on.
Cooling or interior light does notPower does not reach the cabinet. (Try connecting another
operate. No indicator lamps light.electrical device to the power outlet.)
The fuse has blown.
The power plug is not properly connected.
Electrolux 818 18 63-04/7
7 |
ACEC
ELECTROLUX
