Before use
Before using your dishwasher for theFilling with salt
first time:Only use salt specifically designed for use in
dishwashers.
1.Ensure that the electrical and water connections comply
All other types of salt not specifically designed for use in
with the installation instructions
a dishwasher, especially table salt, will damage the water
2.Remove all packaging from inside the appliancesoftener.
Only fill with salt just before starting one of the complete
3.Set the water softener
washing programmes. This will prevent any grains of salt
4.Pour 1 litre of water inside the salt container and then fill or salty water, which may have been spilled, remaining on
with saltthe bottom of the machine for any period of time, which
may cause corrosion.
5.Fill the rinse aid dispenser.
6.Run a "Rinse and Hold" programme.
To fill:
Setting the water softener1.To fill with salt, unscrew the cap of the salt container.
The dishwasher is equipped with a water softener designed to2. Pour 1 litre of water inside the container (this is
remove minerals and salts from the water supply, which wouldnecessary only before filling with salt for the first time).
have a detrimental or adverse effect on the operation of the
3.Using the funnel provided,
appliance.
pour in the salt until the
The higher the content of these salts, the harder your water is.container is full.SALE
SALT
Water hardness is measured in equivalent scales, Clarke,Do not worry if water over
SALZ
French degrees and PPM (parts per Million).flows from the unit when SEL
filling with salt, this is quite
Water hardnessnormal.
ClarkeFrenchPPM
4.Replace the cap making
degrees degrees(Parts perLevel Use of
sure that there is no trace
(°TH)Million)salt
of salt on the screw thread
0 - 60 - 80 - 800NOor on the gasket.SR06
7 - 149 - 2081 - 2001YES5.Screw on the cap tightly.
15 - 2821 - 40201 - 4002YES
29 - 4241 - 60401 - 6003YESThe salt container will require topping up periodically.
43 - 5661 - 80601 - 8004YESThe salt cap has a refill indicator window in the centre.
57 - 6381 - 90801 - 9005YESA green floatis clearly visible when there is salt inside the
container, and almost disappears when the salt has finished
The softener should be adjusted according to the hardness ofreminding you to add salt.
the water in your area. Your local Water Authority can advise
you on the hardness of the water in your area.
The dishwasher is factory set at level 2.
If this level is not suitable for your area the softener should be
adjusted.
If your water is level 0 it is already soft and therefore there
is no need to use salt.
In this case adjust the water softener on level 1 without
using salt.SR11
To adjust the water softener
With a screwdriver turn the selector on the upper front corner
of the machine until the level required corresponds with the
marker.
34
25
21
AA05
5 |
ACEC
ELECTROLUX
