To programme the pyrolytic
cleaning cycle (delayed start,
automatic stop)
If you desire, you can programme the starting and ending
time of the pyrolytic cleaning cycle.
1. Press button to switch on the oven. Turn the oven
knob to position . The symbol appears on
the display and the ?PI? indication means that the
Pyrolytic Cleaning Level 1 is currently pre-selected.
2. The Cooking Duration symbol will flash for 5
seconds. During this time turn the Time/Temperature
knob to or to change to Pyrolytic Cleaning
Level 2 (P2) or go back to Pyrolytic Cleaning Level 1 (PI).
3. Once you have chosen the desired pyrolytic function,
?Pyro? will flash in the display waiting for confirmation
to start the pyro cleaning function.
At this time, push the time function button .
The "End of Cooking" symbol and the arrow
symbol will flash. The control panel will display
the end of the cleaning cycle (that is, the actual
time + pyrolytic cycle duration).
4. While symbol is flashing, turn the Time/
Temperature knob to or to select the required
end of cycle time. Then, the ?Pyro? writing stops
flashing and the oven lamp switches off. The pyrolytic
cleaning cycle will start and stop according your
settings.
5. Some time after the cleaning cycle is started, the
door lock will be activated and the related symbol
will be displayed.
At the end of the pyrolitic cleaning process, the display
shows the time of day. The oven door is locked.
Once the oven has cooled down, an acoustic signal will
be emitted and the door will unlock.
To stop the pyrolytic cleaning cycle at any time,
press button .
Replacing the Oven Light
If the oven bulb needs replacing, it must comply with the
following specifications:
- Power: 40 W,
- Voltage: 230 V (50 Hz),
- Temperature Rating of 300 °C,
- Thread type: E14.
These bulbs are available from your local Service Force
Centre.
To replace the faulty bulb:
1. Ensure the oven is disconnected from the electrical
supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the new one.
4. Refit the glass cover.
5. Reconnect to the electrical supply.
19 |
ACEC
ELECTROLUX
