Water drainageElectrical connection
The end of the drain hose can be positioned in threeBefore plugging the appliance into the wall socket,
make sure that:H
ways:
S
1.the mains voltage corresponds to the voltage given
Hooked over the edgeLIin the technical specifications;
G
of a sink using the2.the meter, fuses, mains power supply and wall
plastic hose guide sup-socket can all take the maximum load required.EN
plied with the machine.Make sure that the socket and plug are compatible
In this case, make sure
without having to use any type of adapter. If neces-
the end cannot come
sary, have the domestic wiring system socket
unhooked when the
replaced.
machine is emptying.
The electric cable must not be extended. If it is too
This could be done by
short and you do not wish to move the socket, replace
P0022tying it to the tap with a
it completely with a longer cable.
piece of string or attaching it to the wall.
Safety standards require the appliance to be
In a sink drain pipe branch. This branch must be
earthed.
above the trap so that the bend is at least 60 cm
The Manufacturer accepts no liability for failure to
above the ground.
observe the above safety precautions.
Directly into a drain pipe at a height of not less than
60 cm and not more than 90 cm.
The end of the drain hose must always be ventilated,
i.e. the inside diameter of the drain pipe must be larg-
Important
er than the outside diameter of the drain hose.
If the socket in your house is not earthed, you have to
The drain hose must not be kinked. Run it along the
floor; only the part near the drainage point must bedo a separate earth connection using the special
raised.green and yellow ground wire which you can find on
the back of your appliance. This wire has to be con-
nected to an efficient earth.
If, instead, your domestic wiring system is already
earthed, this wire must not be used and we suggest
you to simply cut it off and to throw it away.
P0023
27 |
ACEC
ELECTROLUX
