The inlet hose must not be lengthened. If it is tooElectrical connection
short and you do not wish to move the tap, you will
have to purchase a new, longer hose speciallyThis machine is designed to operate on a 220-230 V,
designed for this type of use.single-phase, 50 Hz supply.
Check that your domestic electrical installation can
Important!take the maximum load required (2.2 kW), also
Before connecting up the machine to new pipeworktaking into account any other appliances in use.
or to pipework that has not been used for some time,
Connect the machine to an earthed socket.
run off a reasonable amount of water to flush out any
debris that may have collected in the pipes.
The manufacturer declines any responsibility
for damage or injury through failure to comply
Water drainagewith the above safety precaution.
Should the appliance power supply cable
The end of the drain hose can be positioned in threeneed to be replaced, this should be carried
ways:out by our Service Centre.
Hooked over the edge of a sink using the plastic
hose guide supplied with the machine. In thisPlease ensure that when the appliance is
case, make sure the end cannot come unhookedinstalled the power supply cable is easily
when the machine is emptying.accessible.
This could be done by tying it to the tap with a piece
of string or attaching it to the wall.
In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain pipe
must be larger than the outside diameter of the drain
hose.
The drain hose must not be kinked. Run it along the
floor; only the part near the drainage point must be
raised.
8 |
ACEC
ELECTROLUX
