Left hand door openingBuilding-in
Fig. 4Recess dimensions
Height880 mm
Remove the
Depth550 mm
upper right
Width560 mm
screw and pivot.
6Straighten the
The applianceOs door has been locked in position for
4safety washer (4)
transport by means of pins on both sides.
of the lower right
5According to the door opening direction, remove relevant
hinge. Remove
pins at the top and at the bottom.
the screw (5) and
the pivot (6) 2Fig. 6
D56350 mm
(Fig. 3). For
min. 200 cm
safety reasons bend the washer located under the left For safety
hinge (Fig. 4), by using a tool (for ex. a screwdriver). reasons,
Remove the right door stop hinge (3-Fig. 3).minimum
ventilation must
be as shown in
Inner door reversal
min.
Fig. 6.
2
Fig. 5cm 200Attention: keep
ventilation
Using a openings clear of
screwdriver D526obstruction.
release bracket
180!
(1) by pressing on
Fig. 7
the internal
250540
spring (Fig. 5) and
Air is taken in
1withdraw it from
through the
its seat together
ventilation grille
with the door;
P
PR140at the bottom of
remove plug (2) and Ţt it in the hole left open on the LHthe appliance, but
opposite side;an air outlet
Ogap�, measuring
turn the door through 180°, remove the bracket (1)
50 mm deep by
and reŢt it on the opposite side.
540 mm wide
ReŢt the door and insert the top pin and bottom D240(Fig. 7), must be
bracket (1), pushing it into place.provided in the rear of the kitchen unit. This outlet
gap must also be kept clear between the top of the
To ensure correct storage of food, the door is Ţtted
unit and the ceiling.
with a simple spring device which holds it in the
open position until it is properly closed.Fig. 8
Slide the
refrigerator into
the unit recess
and Ţt the screws
into the top
bracket (Fig. 8)
and into the
bottom hinge
(Fig. 8).
D585
12 |
ACEC
KUPPERSBUSCH
